Albeo
®
AHH2
LED Luminaire
Heavy Industrial High Bay Lighting
BEFORE YOU BEGIN
WARNING/AVERTISSEMENT/ADVERTENCIA
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Prepare Electrical Wiring
Grounding Instructions
The grounding and bonding of the overall system shall be done
in accordance with National Electric Code (NEC) Article 600 and
local codes.
ALB
082
Read these instructions completely and carefully.
Save these instructions for future use.
Risk of electrical shock. Turn power off before inspection, installation or
removal. Properly ground electrical enclosure.
Risk of fire.
Follow all NEC and local codes
for the required wiring
systems for the specific Hazardous Locations involved
.
Ris
q
ues de décharges électriques. Coupez l’alimentation avant d’inspecter,
installer ou déplacer le luminaire. Assurez-vous de correctement mettre à
la terre le boîtier d’alimentation électrique.
Risque d’incendie. Respectez tous les codes NEC et codes locaux.
This device complies with Part 15 of the FCC Rules
, not part of UL Certification
. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN
ICES-005 (A) / NMB-005 (A)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules
, not part of UL
Certification
. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
Electrical Requirements
The LED
luminaire
must be supplied with 120-277 VAC or
347/480 VAC, 50/60 Hz per
electrical ratings on
product
label
and connected to an individual properly
grounded branch
circuit.
Installation Guide
ALB082