Installation Quick Reference
Singlewire-enabled
VoIP V2 Loudspeaker Amplifier
(AC-Powered)
011114
Quick Reference
930351C
© 2016, CyberData Corporation, ALL RIGHTS RESERVED
© 2016, CyberData Corporation, ALL RIGHTS RESERVED
930351C
Quick Reference
Connections
Mounting the Enclosure
Contacting CyberData
1-Sense (+)
2-GND
3-Relay COM
4-Relay NO
5-Line-In(+)
6-Line-In(-)
7-Line-Out(+)
8-Line-Out(-)
9-Spkr Out(+)
10-Spkr Out (-)
CLASS II WIRING
Speaker Connection
Line-Out Connection
Note
: The
Sense/Relay
and
Line-In
features are
not supported with the Singlewire firmware.
Note
:
Line-Out
is 10k Ohm at 2Vpp.
Speaker output is 8 Ohm.
To mount the enclosure:
1. Prepare holes for the screws.
2. Plug in the power adapter and use the
green
Power
light to verify that the
power is on.
3. Plug the Ethernet cable into the VoIP V2
Loudspeaker Amplifier. The yellow
Link
light verifies the network connection.
4. For wall mounting, use the three
#6 x 1-1/4-inch Pan Head Phillip screws
to secure the speaker.
071057A
PHILLIP SCREW (3x)
#6x1 1/4" PAN HEAD
#6 PLASTIC ANCHOR (3x)
151014
531032
Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website:
RMA Department: (831) 373-2601 ext. 136
RMA Email: [email protected]
RMA Status:
Warranty Information:
http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
The Singlewire-enabled VoIP V2 Loudspeaker Amplifier is compatible with InformaCast Version 4.0 and higher.
Getting Started
•
Download the
Operations Guide
PDF file, from the
Downloads
tab at the following webpage:
http://www.cyberdata.net/voip/011114/
•
Create a plan for the locations of your paging amplifiers.
•
Prior to installation, consult local building and electrical code requirements.
Wiring the 125V AC Plug
V2 Loudspeaker Amplifier Parts
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
The green wire with the yellow stripe is a ground connection for Electrostatic Discharge (ESD) protection,
and should not be removed.
To wire the 125V AC plug, consult a licensed electrician and the local building codes in your area.
(1) Assembly
(1) Wall Mounting Kit
(3) #6 Plastic Anchors
(3) #6 x 1-1/4-inch Pan Head Phillip Screws
(1) Enclosure
(1) CAT 5e/CAT6 cable
Additional Parts
View Inside of the Enclosure
(1) PoE Power Injector
