![background image](http://html1.mh-extra.com/html/cyberdata/011530/011530_installation-quick-reference_2701733001.webp)
Quick Reference
931856A
© 2022, CyberData Corporation, ALL RIGHTS RESERVED
© 2022, CyberData Corporation, ALL RIGHTS RESERVED
931856A
Quick Reference
RTFM Button
Contacting CyberData
RTFM button (SW1)
When the device is operational and linked to a
network, you can use the Reset Test Function
Management (RTFM) button (SW1 [see picture])
to announce the device’s IP address or restore
the device to the factory
default settings.
To announce the device’s current IP address:
• Press and release the RTFM button within a
five second window.
Note
The device will use DHCP to obtain the
new IP address (DHCP-assigned
address or default to IPv4 Link Local if a
DHCP server is not present).
To restore the device to factory default settings:
• Press and hold the RTFM button for longer
than five seconds until you hear the device
announce that it is restoring the factory
default settings.
Sales: 831-373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website:
https://support.cyberdata.net/
RMA Department Contact and Status:
https://support.cyberdata.net/
Warranty Information:
https://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
Typical System Installation
Getting Started
•
Download the
Operations Guide
PDF file, from the
Downloads
tab at the following webpage:
https://www.cyberdata.net/products/011530
•
Create a plan for the locations of your Intercoms.
•
WARNING: This product should be installed by a licensed electrician according to all local electrical and building codes.
•
WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation
instructions.
•
WARNING: The PoE connector is intended for intra-building connections only and does not route to the outside plant.
•
WARNING: This enclosure is not rated for any AC voltages!
Intercom Parts
Tool required for assembly: A size #2 Phillips screwdriver
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
IPv4 Link Local
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
IPv4 Link Local
Default Gateway
a
IPv4 Link Local
a. Default if there is not a DHCP server present.
802.3af Compliant Ethernet Switch
Intercom
IP Phone
IP PBX Server
Intercom
Intercom
*
More installation and mounting
options are available in the
Operations Guide
.
(4) #6 X 3/8-inch,100 Deg.,
Flat Head, Self-Tapping Screw
(1) Intercom Assembly
(1) Mounting Kit
The IP Endpoint Company
Installation Quick Reference
SIP Hand Wave Indoor Intercom
SIP Compliant
011530