Copyright © 2016, Critical Link LLC
60-000019-1_RevA
Thank you for choosing the MitySOM-335x Maker Transition Kit from Critical Link.
In this Quick Start Guide you will be guided through the initial steps of setting up your MitySOM-335x Maker
Transition Kit. This Kit will allow you to transition an existing Beaglebone® based design to the Critical Link
MitySOM-335x System on Module; included and installed in the Maker Transition Board. A Linux Operating
System is pre-loaded onto the Micro SD to support this transition. The MitySOM-335x Maker Transition Board
is designed to offer similar interfaces as that of the Beaglebone to ensure a quick hardware and software
transition.
The MitySOM-335x Maker Transition Kit contains the following:
Provided Hardware:
MitySOM-335x Maker Transition Board with:
o
MitySOM-335x System on Module (Installed)
o
4GB of eMMC Flash Memory
o
Dual 46-pin Cape Compatible Headers
o
MicroSD Card Connector
o
10/100 Networking
o
HDMI Output with audio
o
USB OTG (Mini B) and Host (A) Ports
o
Single 5V DC Input
o
JTAG and UART Debug interfaces
USB to UART Debug Serial cable
AC/DC 5V 2A adapter
SD Card pre-loaded with Linux Operating System and demonstration application
Printed Documents:
MitySOM-335x Development Kit Quick Start Guide (this document)
Software and documentation:
Please visit our support site for updated software and documentation
o
https://support.criticallink.com/redmine/projects/mitysom-335x_maker/wiki
Suggested Hardware (not provided):
Widescreen HDMI display and MicroHDMI to HDMI Adapter
USB Mouse (for interaction with Demo application)
