DPT Series
LED Post Top Luminaire
LPN00253X0001A1_A
1 of 2
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
NOTE:
Be sure to disconnect HID ballast before
installation of the DPT.
STEP 1:
Remove door cover shown in
Figure 1
by loosening
screw located on the side, and gently pulling cover
off. See
Figure 1.
STEP 2:
Attach DPT luminaire to mounting base by inserting
(2) supplied #6 5/8" long screws into customer
supplied bracket and screwing into the base of DPT
luminaire. See
Figure 2.
STEP 3:
Feed power supply wires using customer supplied
flexible conduit through opening in door cover. See
Figure 2.
NOTE:
The opening in the door cover accepts 1/2"
flex conduit.
STEP 4:
Make wiring connections per
Electrical Connection
section on the back page.
STEP 5:
Reattach door cover that was removed in Step 1 by
tightening screw.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant
l’installation.
2. This luminaire must be installed in accordance with the NEC or your
local electrical code. If you are not familiar with these codes and
requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n’êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
1
Loosen Screw
2
Door Cover
#6 5/8" Long
Screws
Opening for Customer
Supplied Conduit
