&RPSDT
&RPSDT
3UROLDQW5
3UROLDQW5
TSS DOCUMENT #:
Compaq
05/96 Doc # MT 1667 - 0025
Page 1 of 2
© International Business Machines Corp. 1996
All rights reserved
Compaq Proliant 2000/4000/4500/4500R
Specifications
Processor
x
Intel 486/50, 5/66,100,133,166; R is rack-mountable
Memory
x
2000: 16/32MB RAM up to 512MB; 4000: 64MB RAM up
to 512MB; 4500/4500R: 16MB up to 1.024GB
I/O Expansion Slots
x
8-32bit EISA bus master slots
Diskette Drive
x
1-3.5” 1.44 diskette drive
Integrated Features
x
2-Serial, parallel, pointing device port, 32-bit Fast SCSI-2
network, integrated graphics
Internal Expansion Bays
x
2000/4500R- 5, 4000/4500: 7-internal hot pluggable bays
I/O Architecture (Buses supported)
x
Compaq Flex, TriFlex PC architecture
Power Supply
x
445 watt power supply, 4500/4500R: 488/540 watt
Diagnostics
x
Normal Post Diags performed on Power UP of system.
x
For Advanced Diags use Diskette version 9.0
x
Troubleshoot according to errors found during test
Tools And Software Requirements
x
Flat bladed and Torx T-8, T-10, and T-15 screwdrivers
x
Needle nose pliers, * ROM removal tool
x
Diagnostics and formatted blank diskettes
x
Anti-static wrist strap
Jumper Settings for SCSI ID
Proliant 4500/4500R
Pin3
Pin2
Pin1
Drive Bay#
SCSI ID
ID2
ID1
ID0
6
6
ON
ON
OFF
5
5
ON
OFF
ON
Switch Settings Proliant 2000/4000
SW2 (003116, 003862, 004486)
Switch
Position
Function
S1
OFF*/ON
turns on video/turns off video
S2
OFF
turns off processor
ON
turns on processor
S3
OFF*
reserved
S4
OFF*
turns off diskette boot
ON
turns on diskette boot
S5
OFF*
turns off pwr-on password
ON
turns on pwr-on password
S6
OFF*/ON
turns off NV RAM/turns on
Switch Settings Proliant 4500/4500R
SW1 (004308)
Switch
Position
Function
S1
OFF*/ON
turns on video/turns off video
S2
OFF*
turns on configuration lock
ON
turns off configuration lock
S3
OFF*
syst. installed in tower chassis
ON
syst. installed in rack chassis
S4
OFF*
dsktte boot based on config
ON
dsktte boot despite config
S5
OFF*
turns on pwr-on password
ON
turns off pwr-on password
S6
ON
clears config. memory
* Default
Removal Procedures
Before beginning removal complete the following:
1. Turn off the computer and any peripheral devices.
2. Disconnect AC power cord from the outlet and system.
3. Disconnect all peripheral devices.
System Cover
Warning: High voltage is present, use caution when running
the Proliant without the system cover on.
1. Lift and remove the front bezel door
2. Loosen thumb screws and remove at front of panel
3. Slide system unit cover forward then up
4. Rack-Mounted: Turn 1/4 turn screws on front panel.
5. Slide the cover back and up.
