A.
E.
F.
D.
B.
C.
Kit Includes
Tools Required
A.
B.
C.
D.
E.
1- 60343 Motor Mount w/ MM5 series module
2- 40002 8/32 X 1/4” Phillips head screws
1- 50030 8’ Lead w/ VD Connector
1- 50944 Molex Pigtail
1- 40144 Dogging Hole Cap
• Cordless Drill
• Hammer & Pin Punch(recommend)
• 3/16 & 3/32 drill bit
• 5/16 Nut driver (recommended)
• #2 Phillips head screwdriver
v L P - U L- M K I T
INSERT Instructions
The Command Access VLP-UL-M-KIT is a Field-installable motorized latch-pullback kit for the Von Duprin 99/98 & 35/33 series
devices.
# 2 0 4 5 3 _ c
U S c u s t o m e r s u p p o r t 1 - 8 8 8 - 6 2 2 - 2 3 7 7 | w w w . c o m m a n d a c c e s s . c o m | C A c u s t o m e r s u p p o r t 1 - 8 5 5 - 8 2 3 - 3 0 0 2
SPECIFICATIONS:
• Input Voltage: 24VDC +/- 10%
• Average Latch Retraction Current: 900mA
• Average Holding Current: 200mA
• Wire Gauge: Minimum 18 gauge
• Direct wire run - no relays or access control units in-between power supply & module
Recommended Power Supplies:
All Command Access exit devices & field installable kits have been thoroughly cycle tested with Command Access power supplies at our factory. If you
plan on using a non-Command power supply it must be a filtered & regulated linear power supply.
G.
Fire rated dogging kit
1- 50872- Fire Rated Drilling Template (Old Devices)
1- Replacement Dogging Tail Piece (40006 + 40800 + 50872)
F.
G.
