ADJUSTMENTS
AND
INSPECTIONS
SIMPLA 45-50
Doc. 10001244
Em. 04/2007
Rev. 00
Pag.
1 di 6
REPLACE AND DELETE THE DOCUMENT RC2300 REV 06 OF 10/2005-SS, ISSUED 06/1999-GG
READ THE USE AND MAINTENANCE HANDBOOK
Inspection of the electrical layout
1.
Check the functions of the electrical layout: switches, motors,
solenoid valve.
2.
Check the
control functions and the coupling and
uncoupling of the brushes
.
3.
Control the operation of the chopper
(Machine with traction).
4.
If necessary adjust the chopper-card as
follows:
•
Lift the machine (Traction wheels without
contact to the floor)
•
Open the handlebar unscrewing the four
underlying screws
•
Fix the clamps of the tester (V-DC) to the
connections
M+
and
M-
of the chopper-card
•
Switch on the main key
•
Insert the forward gear until the 1
°
Microswitch snaps (first speed)
•
The tester should indicate 9-10V. If
necessary adjust the
trimmer “I”
(first
speed), so that the above mentioned voltage
is obtained
•
Activate the forward gear completely, so that
the 2
°
microswitch snaps. The tester must
indicate 24V (max. battery); Otherwise
control the voltage of the battery and control
the cables.
•
Acceleration adjustment: Set the
trimmer
“L”
(ACC), so that its position is turned
clockwise about 30°/45° to the central
position. With this adjustment you obtain the
desired voltage (9-10V or 24V) in about 4
seconds.
•
Check the function reverse gear
•
Check motor braking (after release of the
handle bar the machine should stop in about
1 meter).
