Install the Snap Lid System
®
adapter specific to your spray
gun model with a Wrench
#22. Keep the adapter
installed on the spray gun.
Mix paint in cup: Mixing, reducing
and mechanical agitation can be
done in the Snap Lid System
®
cup
prior to the Snap Lid System
®
lid
being snapped on.
Attach lid to cup: starting at the
side nearest the air-vent with the
lid on an angle, push down with
both thumbs and press down
around the perimeter of the lid until
the lid snaps securely onto the cup
and a seal is achieved.
Attach the spray gun
onto the lid by twisting
the threads and
tightening until secure.
Rotate gun/cup
assembly right side up
and attach air hose.
Tilt the spray gun forward
and backward to release
any air below the filter.
Now begin spraying.
The Snap Lid System
®
will spray just like a
vented cup.
When finished with spraying, turn
the cup upside down and pull
the spray gun trigger to allow
flow of product back into the cup
from the gun. Remove Snap Lid
System
®
and clean spray gun.
1
2
3
4
5
6
7
8
Only
Colad!
Snap Lid System
®
Quick Start-up Guide
