NIGHTPROBE
®
IN LIGHTBAR
INSTALLATION
& OWNERS
MANUAL
REMOTE
CONTROLLED
SPOTLIGHT
Introduction
The NightProbe
, NP 130, product can be mounted in the center section of a Code 360, Excalibur or MX
lightbar. This offers the user an unobstructed 360 degrees of light around the vehicle.
Installation & Mounting
1. Install the circular gasket on the upper surface of the lens cover and spacer.
2. Route the cables from the bottom of the spotlight through the gasket, lens cover as shown in
Figure 2.
3. Place the other two spacers on the lens cover. They will be sandwiched between the lens cover and the
mounting plate.
4. Place the mounting plate over the spacers, align the holes in the mounting plate with the holes in the lens
cover.
5. Attach the spotlight with four #6x3/4” screws to the mounting plate.
6. Remove the center lens of the lightbar and keep the four lens clips for reuse.
7. Route the cables through the existing hole in the bottom of the lightbar, insure that there is adequate
length to reach the area in which the controller is to be mounted.
8. Install the spotlight mounting bracket to the lightbar frame using eight #8 x .270” screws. The bracket
should fit snugly between the plastic ribs of the lower lens to ensure alignment with the lens/mtg plate
assy.
9. Install the spotlight and lens/mtg plate to the lower lens being careful not to pinch the cables. Fasten with
four #14 x 3/4” washer seal screws.
10. Reinstall the four lens clips.
11. Connect the wiring and the control box per instructions with the spotlight.
