Nord Modular G2 Expansion board
Warning! The installation must be carried out by authorized service personnel, otherwise any warranty
becomes void.
The Nord Modular G2 Expansion kit contains
1. The Expansion board
2. Three posts
You will also need a #2 phillips screwdriver and a small wrench.
Installation in the Nord Modular G2 keyboard model
1. Remove the detachable power chord and then remove the 7 black panel screws (marked with circles) according
to the figure. You may also have to loosen (but not remove) the 2 screws marked with triangles in the figure.
2. Remove the 2 larger black screw on the bottom
of the synth (underneath the Mod Wheel and
3. Gently, pull up the lid.
Warning! If you don’t have an anti-static mat, you
have to make sure your free hand is grounded
while handling the Expansion board.
4. Remove the three screws that hold the large board (see figures below) and remove the washers. Replace the
screws with the three enclosed posts. Use a wrench to secure the posts. Hold the Expansion board by the outer
edges so you don’t touch any traces or components. Fit the Expansion board firmly on the two sockets. Secure
the Expansion board on the posts with the three previously removed screws and washers.
5. Gently push the lid back down. Power up the Nord Modular G2 and check connections.
6. Put all the black panel screws back on. Don’t forget the screw on the bottom underneath the Mod Wheel.
Please note: When you power up the Nord Modular G2, the synth will automatically detect the Expansion board.
In software 1.2 and upwards the letters ’Exp’ after the OS version number will also appear in the main display.
P
a
rt
No
. 50219
