1
Form: OMM-30-0811
Supersedes Form: OMM-30-709
Part No.: 01009
Installation, Safety, Operation & Maintenance Manual and Parts List for
Models 33S, 50S, 75S, 100S, 150S, 200S and 300S Portable Dust Collectors
NOTICE:
Read this complete manual before attempting to assemble,
install, operate, move, inspect or service this Dust Collector.
Inlet
Nozzle
Size
Approx.
Ship
Wt.
Inlet
Hose
Size
Blower
Wheel
Dia.
Max.
Drum
Dia.
Full Load Amps
4 x 4
5 x 5
5 x 5
6 x 6
7 x 7
7 x 7
7 x 7
Maximum CFM at 0” S.P. (clean drum, dust bag, with 5
feet of inlet hose and inlet nozzle).
Maximum additional static pressure (SP) at which point
there will be no air flow.
Minimum micron size at which standard dust bag will
capture 99%.
See Section V. INSTALLATION, Section A on page 6.
Starting amps are approximately 6-7 times the full load
amps. High voltage amps are 1/2 of low voltage amps.
Amp loads shown are approximate and will vary with
different motors and/or brands.
All dimensions above are nominal. For complete
dimensions, see page 15.
All Cincinnati Fan products are packaged to minimize any damage during shipment. The freight carrier is responsi-
ble for delivering all items in their original condition as received from Cincinnati Fan. The individual receiving this
equipment is responsible for inspecting this unit for any obvious or concealed damage. If any damage is found, it
should be noted on the bill of lading before the freight is accepted and the receiver must file a claim with the
freight carrier.
ATTENTION: Receiving Department
LONG TERM STORAGE NOTICE
If this dust collector will NOT be installed and put into service within 30 days, refer to the “Long Term
Storage Instructions” on page 2. Failure to follow all applicable long term storage instructions will void
your warranty. This dust collector must be stored indoors in a clean, dry location.
Models
33S, 50S & 75S
Models
100S, 150S & 200S
Cans or Drums
are not included
