FIBER SEGREGATION KIT
IIS-735475, 02/29/08, Rev. 1, CPI/J Garza
800-834-4969 • [email protected] • www.chatsworth.com
This drawing contains proprietary and confidential information and is protected by U.S. and international law.
Unauthorized reproduction, disclosure or use of the drawing or the information therein is expressly forbidden
except as agreed to in writing by Chatsworth Products, Inc.
Page 1 of 3
Installation Instructions
Verification
The Fiber Segregation Kit is for use with the Evolution
™
Vertical Cable Managers
in the following configurations:
The number of kits per manager depends on the position of the Movable Mid-
Section in Evolution g2 double-sided managers and the width of the vertical cable
manager as listed in the table below:
Cable
Manager
Width
Single-Sided or
Double-Sided with
50/50 Front/Rear Split
Double-Sided with
60/40 Front/Rear
Split
6” (150 mm)
0
1
10” (250 mm)
1
2
12” (300 mm)
2
2
Verify Mid-Section Locations
In order for the Fiber Segregation Kit to mount to the Accessory Panel on the
Single Sided Evolution g1 or the Moveable Mid-Section on the Double Sided
Evolution g2, the distance between the panels must be 18.6 inches.
Fiber Segregation Kit
18.6”
