DISCOVER PROTEIN
HYDROLYSIS
INSTALLATION AND OPERATION
INSTRUCTIONS
HARDWARE ASSEMBLY AND SETUP
PRESSURE SENSOR
1.
Connect the 9-pin sensor connector from the valve panel into the pressure port (9-pin
1.1.
receptacle) on the rear of the Discover (Figure 1).
FIBER-OPTIC TEMPERATURE PROBE
2.
Connect the end of the serial cable labeled “To Temperature Box” to the temperature control
2.1.
box. Connect the other end of the cable to COM2 on the read of the Discover (Figure 1).
Connect the blue fiber-optic temperature probe to the temperature control box, taking care not
2.2.
to bend the probe.
Figure 1. Instrument Connection Ports (COM2 indicated in red; Pressure Port indicated in yellow.)
600313
Rev. 5
10/6/2008
NOTE
The Discover Protein Hydrolysis is only compatable with Discover firmwave versions 201A14 or later.
The current firmware version on the Discover can be found by pressing EDIT and using the arrow keys
to select System Info.
