Pin
A
A
B
B
B
B
Lever
arm
TOP
BOTTOM
TOP
Lever
arm
BOTTOM
TOP
BOTTOM
TOP
Lever
arm
Pin
BOTTOM
9500M
SERIES
MORTISE LOCK EXIT DEVICE (FIRE) - INSTALLATION INSTRUCTIONS
1. Device is factory pre-set as LHR
2. Knock out the pin in the direction (as shown), take
out the lever arm assembly
3. Rotate the chassis 180° and install the lever
arm and insert pin as shown
4. Device is converted to RHR
TO CHANGE HAND OF EXIT DEVICE CHASSIS:
TO CHANGE LOCK BODY HAND
OF FIELD REVERSIBLE MORTISE LOCK:
NOTES:
a) Prepare door and door frame as per supplied templates and
instructions on Sheet 2.
b) If no trim is used, install lock body and exit device only. Level railing
assembly and attach railing end mounting bracket to door using
through bolts (not supplied) and machine screws.
c) If trim is used, refer to sheet 2 and to trim installation instructions
to prepare door for the appropriate trim.
9500M-INS-EN-2015-02
1/2
If it is necessary to change handing, follow the instructions below:
1. Use hex key to unfasten the screw in the hole behind latch bolt (green label).
2. Pull latch bolt out from the front of the lock case.
3. Rotate latch bolt 180° to proper handing and push latch bolt back into lock case.
4. Securely tighten the screw in the hole and secure with Thread locker (Loctite 242).
5. Handing is now reversed.
LEFT HAND REVERSED (LHR) SHOWN
Right hand (or LHR) lock shown
for LHR exit device installation
Before installing the exit device, verify the following:
1. Door is properly fitted and hung.
2. Door surface on which the exit device will be installed is flush and flat.
3. Verify if the exit device length is suitable for the applicable door width. If the exit device mounting rail requires to be shortened see below:
a. The 3’ exit device model can be cut to fit doors from 30” (762mm) to 36” (914mm) in width (refer to section 4 on sheet 2.)
b. The 4’ exit device model can be cut to fit doors from 36” (914mm) to 48” (1219mm) in width (refer to section 4 on sheet 2.)
4. Exit device handing (refer to illustration below.)
5. Lock function and trim compatibility.
6 Review all templates and installation instructions prior to any door preparation.
NOTE: Mortise exit device is meant to be used with a compatible exterior trim. Refer to section 2 on page 2.
GENERAL NOTES
Through square hole
Hole (green label)
Latch bolt
Hex key
Push Pad
Sliding Cover
Main Chassis Cover
Mortise lock
(LHR shown)
Strike
Mortise lock
body screws
Inside Door
Surface
Screws
A-Machine screws
#10-24 UNC x 3/4”
B- Machine screws
#10-24 UNC x 3/4”
or wood screws
#10 x 1-1/4”
Strike
screws
Mounting Rail
Exit device location on door
must be flush and flat
Rail Mounting
Bracket
End Cap
Main Chassis
