IDL SERIES
INLINE DUCT BLOWERS
OPERATION INSTRUCTIONS AND PARTS MANUAL
IDL SERIES MODELS: IDL07, IDL09, IDL10, IDL12, IDL15
GENERAL SAFETY
Rotating parts, (pulleys, shafts and belts) on fans should not be exposed. Where these components are not protected by ductwork, cabinets
or covers, appropriate guards should be employed to restrict exposure to rotating parts. Access doors should not be opened with the fan
operating to avoid foreign objects being drawn into the system. On initial start-up, a careful inspection should be carried out to ensure no
foreign material is present which could become airborne in the system.
Read installation and operation instructions carefully before attempting to install, operate or service Canarm/Delhi IDL Series Blowers.
Failure to comply with instructions could result in personal injury and/or property damage.
Retain instructions for future reference.
BEFORE YOU BEGIN
Inspect unit for damage, report any shipping damage to carrier. Check all fasteners, re-tighten as required. Rotate the blower wheel by
hand to ensure free rotation. If rubbing occurs, loosen the set screw(s), re-position the wheel to the shaft center, re-tighten set screws.
INSTALLATION
Install the mounting brackets to the
holes on the blower sides to achieve an
ideal mounting position.
Use the 5/16 hole plug in 7010053 parts
bag to block the holes not needed.
Suspend the unit by threaded rod
(provided by others) through the holes
on the mounting brackets.
A
C
D
B
G
F
E
G
E
D
H
I
A
B
C
D
E
F
G
H
I
Max HP Shaft
D
ia.
I
D
L07
29
23
13
8 1/2
15
1/8
7/8
22 1/2 25 5/8
3/4
3/4
43 lbs
I
D
L09
32
26
16
10 7/16
18
1/8
7/8
25 1/2 28 5/8
3/4
3/4
55 lbs
I
D
L10
36
32
19
24
12
5/8
7/8
29 1/2 34 5/8
1 1/2
3/4
65 lbs
I
D
L12
42
36
21 5/8 13 7/8
28
1/2
1
33 7/8 38 5/8
1 1/2
3/4
82 lbs
I
D
L15
46
42
25
16 3/4
32
1/2
1
35 7/8 49 5/8
3
1
140 lbs
D
IMENSIONS (IN
C
HES)
Weight
(without motor)
FIGURE 1
NOTE: Flexible inlet & outlet duct
collars and vibration isolator are
recommended to minimize
vibration transmission and lower
the noise level.
IDL-M-07_20_16
Page 1 of 5
RIGID MOUNT
Mounting brackets
shipped loose.
Can be installed at
3 different levels
WHEEL ROTATION
ISOLATOR MOUNT
Threaded rod provided by others.
Vibration isolator sold as accessory.
