www.camsat-cctv.com
TECHNICAL
SUPPORT
tel.+48 52 387 36 58
Mon–Fr 8.00 AM–4.00 PM
Full instructions available on www.camsat-cctv.com
An operational mobile camera
with its own battery and LTE module
for video monitoring
QUICK START
ver. 1.3
Feature
Full instructions available on www.camsat-cctv.com
The mobile camera in transport should be turned o
ff
.
During start-up of iCam-PowerHD system, follow these steps:
EU
EU
POLISH
MARK
POLISH
MARK
• iCAM-PowerHD system that contains:
2MPX PTZ IP Camera
Battery - iCAM-AKU 64 14,8V 64Ah Li-ion
4G LTE module
SD card 128GB
• Quick-connector mounting mounting accessories
• LTE Antenna x2pcs
• Key
• Desktop battery charger 230V AC
• User Manual and CE Declaration
Producer:
CAMSAT Gralak Przemys
ł
aw
Ogrodowa 2a
86-050 Solec Kujawski
Poland
+48 52 387 10 97
+48 52 387 36 58
+48 52 387 54 66
Sales:
+48 52 387 10 97 (ext. 21 and 22)
Mon.-Fri. from 8.00 to 16.00
European websites:
www.camsat.com
www.camsat-cctv.com
Technical support / Service:
+48 52 387 36 58 (ext. 25 and 26)
Speci
fi
cations
iCAM-PowerHD is a new version of iCAM system adapted for fast operational applications.
Equipped with its own power supply for more than 3 days of continuous operation, an HD observation
camera with the possibility of remote setting of the PTZ observation direction and an advanced remote
system access via GSM LTE. Versatile applications, very fast assembly, full access to live images and
PTZ control guarantee full mobility in all operating conditions.
Starting at the destination point
The iCAM-PowerHD system with the IP camera should be mounted only for permanent, stable
construction of walls and masts. The holder should be mounted vertically, the handle/padlock it must be
at the bottom. Additionally, you should install steel safety cable to a separate anchors or any other part
of the pole. Safety cable must be mounted to a solid, robust construction, which will guarantee the device
with the camera will be held in case of an emergency. The installer is responsible for correct camera
installation in accordance with these instructions and safety standards!
Slide the camera (antenna up) into the holder, and then attach the safety cable and padlock to secure the
camera or twist two caps on the bolts to prevent unauthorized assembly.
After turning the ignition key to the "I" it should light up green LED on the external panel for a while.
iCAM-PowerHD starts to record the image, and full remote access to the device will be possible.
WARNING
After starting iCAM-PowerHD, remove the key from the ignition, leaving it in position "1" to prevent
the shutdown of the system by third parties.
Actions taken during each system start-up
Package content
TECHNICAL
SUPPORT
tel.+48 52 387 36 58
Mon–Fr 8.00 AM–4.00 PM
