CALIBER
®
952-985-9999
Assembled on 8 June 2020
G:\Shipping & Receiving Department\Caliber Instructions\13561 - CI5079 - Moto
RampPro.docx
CALIBER MOTO RampPro
TM
Assembly Instructions for Part No. 13561
Hardware Included:
1 – Retrax Accessory Strap (PN. 13548)
Tools Required:
6mm Allen Key
13mm Socket/Wrench
READ ALL INSTRUCTIONS CAREFULLY PRIOR TO ASSEMBLY
-
Maximum recommended load surface height: 45
inches
-
Maximum loaded vehicle width - complete
ramp: 38 inches
-
Rated capacity of complete ramp: 1,200 lbs.
-
Rated capacity of each side section: 600 lbs.
-
Always use safety straps attached to both the transport
vehicle and ramp
-
Always use additional safety strap when the ramp
is separated. Additional retractable straps
available (Caliber PN 13548)
-
Always load or unload on a solid, level, and stable
surface with the transport vehicle in park, parking
brake on, and engine off
CALIBER, INC. LIMITED LIFETIME WARRANTY
Caliber, Inc. warrants that this product will be free from defects in material or workmanship under normal use, installation and service. Several parts of Sled Wheels
are considered wear items: the wheels, rubber finger covers and extenders, rubber hook plate, and rubber latch cover, and are available for purchase from Caliber
dealers. Caliber, Inc. reserves the right, before having any obligation under this limited warranty, to inspect the damaged Caliber product. All warranty shipping costs
for inspection shall be borne solely by the purchaser. This limited warranty is non-transferable. Contact Caliber, Inc. at
www.caliberproductsinc.com/warranty
or at
952-985-9999 for warranty service procedures.
DISCLAIMER
Caliber, Inc. shall not be liable for any special, incidental or consequential damages, including, but not limited to, lost revenues, lost profits, personal injury, damage
to property, and third-party claims, arising out of any warranty, contract, statutory or tort. Notwithstanding the term of any limited warranty or any warranty implied
by law. In the event that any limited warranty fails of its essential purpose, in no event will Caliber’s entire liability exceed the purchase price of this product.
Step 1:
-
Remove Retrax accessory strap from top rung of
ramp and install using a 6mm Allen and 13mm
wrench.
-
Use elongated slot fixed in the center of the ramp to
clip the 2” hook for storage.
Use with four-wheeled vehicles:
Step 1
:
-
Remove all three (3) bolts from the hinges of the
ramp – place back in hinges for storage – tighten
Step 2
:
