Quality since
1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
LT15
Multi-Rack
for Utility Landscape Trailers
Holds most hedge trimmers, chain saws, and
hand blowers.
—continued on other side
1
3000058
1
Multi-Rack Weldment
2
3000057
1
Bracket, Hedge Trimmer, Multi-Rack
3
3000538
1
Pin, Detent
4
TS9
2
Strap, Rubber Tarp 9”
5
9225
4
S-Hook, 2-1/2” Zn, Tarp Strap
6
-
3
Washer, Flat 3/8” USS Zn
7
-
2
Screw, HHC 3/8-16 x 1-1/4 Gr 5 Zn
8
-
2
Nut, Nylock 3/8-16 x 7/16 Zn
ITEM
PART NO.
QTY.
DESCRIPTION
Bill of Materials
etc., before drilling any holes. Any damage
to trailer during installation is installer’s sole
responsibility.
3.
Drill 13/32” holes in the positions marked.
4.
Bolt the rack to the trailer with the 3/8-16 x
1-1/4 screws, 3/8” flat washers, and nuts supplied
(2 or 3) and tighten. If the hedge trimmer bracket
is used, omit the washer under the head of the
screw that holds it. Hedge trimmer bracket must
be mounted in the location shown in illustration.
Important!
Before you begin installing:
1.
Read and understand these instructions
completely.
2.
Verify that you have received all the parts
listed in the bill of materials.
CAUTION:
Always wear safety glasses when using power tools.
Utility Trailer Installation Instructions
Tools Required:
•Two 9/16” wrenches and/or sockets
•Electric drill
•13/32”drill bit
1.
Place the Multi-Rack on the rail or fender
of your utility trailer where you would like it
mounted.
Make sure the rack does not extend
past the widest part of the trailer.
If you are
mounting the Multi-Rack close to another rack
or obstruction, verify that the tools you would
like to place in the rack fit in the area selected.
2.
Mark the position of the holes on the trailer
rail (2) or on the fender (3). Make sure the marks
made on the trailer rail are centered in the rail
angle’s web. If you are mounting the rack on the
trailer’s fender and wish to use the hedge trimmer
attachment, you must use the center hole where
the bracket is to be mounted.
Warning! Check under the trailer and fender
for locations of brake lines and electrical wiring
