CW-APS BREWING & CLEANING INSTRUCTIONS
7. Holding time - discard after
60 minutes.
6. When brewing is complete,
discard the grounds and filter.
5. Open the flip lid and pour one
pitcher of tap water into the
opening on top of the brewer.
42054.0000A 04/09 ©2009 Bunn-O-Matic Corporation
42054 040909
1. Insert a BUNN
®
filter into the
funnel.
4. Place an empty Air Pot under
the funnel.
3. Slide funnel into the funnel rails
of the brewer.
2. Pour in fresh coffee. Shake
funnel gently to level grounds.
5. With the sprayhead removed,
insert a deliming spring into
the sprayhead tube until
approximately two inches of
the spring remain visible. Saw
back and forth five or six times
to loosen any lime deposits.
4. Clean mineral deposits and
rinse. Make sure all holes are
open.
3. Remove the sprayhead.
2. Use a clean damp cloth rinsed
in mild, non-abrasive detergent
to clean the sprayhead panel.
1. Clean and sanitize the funnel.
CLEANING
BREWING
6. Flush the tube by running a
brew cycle using an empty
funnel and Airpot. When the
cycle is completed, replace the
sprayhead.
7. Use a clean damp cloth rinsed
in mild, non-abrasive detergent
to clean all outer surfaces.
RELEASED FOR PRODUCTION
DIR Num: 42054.0000 19, May 2015
