background image

ELECTRONIC 

DIGITAL SAFE

Model

45891

InstallatIon and operatIon InstructIons

Due to continuing improvements, actual product may differ slightly from the product described herein.

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our website at: http://www.harborfreight.com

to preVent serIous Injury, read and understand 

all warnIngs and InstructIons before use.

Copyright

©

 2001 by Harbor Freight Tools

®

.  All rights reserved.  No portion of this 

manual or any artwork contained herein may be reproduced in any shape or form 
without the express written consent of Harbor Freight Tools.

for technical questions or replacement parts, please call 1-800-444-3353.

reVIsed 07b

Summary of Contents for 45891

Page 1: ...ur website at http www harborfreight com To prevent serious injury read and understand all warnings and instructions before use Copyright 2001 by Harbor Freight Tools All rights reserved No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools For technical questions or replacement parts please call...

Page 2: ...Keep the invoice with this manual Write the invoice number on the inside of the front cover Keep the manual and invoice in a safe and dry place for future reference Safety Warnings and Precautions WARNING When using this product basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment Read all instructions before using this product Use the ri...

Page 3: ...ither the A or B Key The Safe will beep twice to confirm that the Code has been changed Important If the Safe beeps three times then the Code has not been accepted and you must repeat the steps above To Change the Batteries If the Red Light and the Green Light are both lit at the same time it is time to change the Batteries Follow the instructions for opening the Safe The Battery Compartment is lo...

Page 4: ... drill a small pilot hole through the template to mark the hole placement Next drill four holes in the correct location using a concrete drill bit Drill the holes the same diameter as the fasteners and 2 deep Hammer the fastener in the hole with the flat side going into the hole first Use a wood block between the bolt and the hammer to protect the threads Place the safe over the bolts with the nut...

Reviews: