Wireless Mouse/M997AP III/EMPREX,BTC
Hardware Installation
1.
Plug the receiver connector into your available USB port on PC.
2.
Make sure the batteries of the mouse are installed correctly, please follow the
polarity signs in the battery compartment.
3.
Please make sure the slide switch on the back of the mouse is switched to “
on
”
before using the mouse. When not in use, please turn the power switch to “
off
” for
power saving.
M997AP III
¾
Change the cursor pointer speed
You can modify the mouse pointer speed settings in the control panel.
1.
Open the Start Menu by clicking “Start” at the lower-left corner on the screen
2.
Then click on Settings / Control Panel / Mouse
3.
In the Mouse Properties window that appears, click the Motion tab
4.
Move the slide bar toward either the faster end or the slower end
5.
Click OK to exit and make the change effective
Pairing Procedure
The wireless mouse can operate out of the box immediately after you plug the receiver USB
connector into your PC USB port. If it can’t work, please visit our website at
http://www.emprex.com/
to download and install the “Pairing Tool.”
Note:
1.
You don’t have to pair ID again after changing batteries. If it can’t work, please follow the steps
above to complete ID pairing.
2.
The mouse can operate freely up to 10 meter from the receiver.
3.
Mouse battery life is up to 6
months. It depends on the intensity of usage.
System Requirements
-
Microsoft® Windows® 7, Windows® XP and Windows Vista® operating systems
-
Available USB port
English
Receiver
storage slot
