PAGE 1 OF 29
0421 IH-3071
H-3071
NAIL GUN
1-800-295-5510
uline.com
INSTRUCTIONS
SAFETY INSTRUCTIONS
WARNING! EYE PROTECTION which conforms to
ANSI specifications and provides protection
against flying particles both from the FRONT
and SIDE should ALWAYS be worn by the
operator and others in the work area when
connecting to air supply, loading, operating
or servicing this tool. Eye protection is required
to guard against flying fasteners and debris
which could cause severe eye injury.
The employer and/or user must ensure that
proper eye protection is worn. Eye protection
equipment must conform to the requirements
of the American National Standards Institute,
ANSI Z87.1, and provide both frontal and side
protection.
NOTE: Non-side shielded spectacles and
face shields alone do not provide adequate
protection.
CAUTION: Additional safety protection will be
required in some environments. For example,
the working area may include exposure to
noise level which can lead to hearing damage.
The employer and user must ensure that any
necessary hearing protection is provided and
used by the operator and others in the work
area. Some environments will require the use
of head protection equipment. When required,
the employer and user must ensure that head
protection conforming to ANSI Z89.1 is used.
AIR SUPPLY AND CONNECTIONS
WARNING! Do not use oxygen, combustible
gases or bottled gases as a power source for
this tool, as tool may explode, possibly causing
injury.
WARNING! Do not use supply sources which
can potentially exceed 200 psig as tool may
burst, possibly causing injury.
WARNING! The connector on the tool must not
hold pressure when air supply is disconnected.
If a wrong fitting is used, the tool can remain
charged with air after disconnecting and thus
will be able to drive a fastener even after the
air line is disconnected, possibly causing injury.
WARNING! Do not pull trigger or depress
contact arm while connected to the air supply
as the tool may cycle, possibly causing injury.
WARNING! Always disconnect air supply:
1) Before making adjustments; 2) When
servicing the tool; 3) When clearing a jam;
4) When tool is not in use; 5) When moving to
a different work area, as accidental actuation
may occur, possibly causing injury.
LOADING TOOL
WARNING! When loading tool: 1) Never place a
hand or any part of body in fastener discharge
area of tool; 2) Never point tool at anyone;
3) Do not pull the trigger or depress the trip
as accidental actuation may occur, possibly
causing injury.
BOSTITCH
Para Español, vea páginas 10-20.
Pour le français, consulter les pages 21-29.
