Bluefin LED Piranha P6N, Installation Manual

Page: 1 / 6

1
Bluefin Led Underwater lights.
P6N/P6CC Installation manual.
Thank you for choosing Bluefin LED underwater lights, our products have been designed and tested
rigorously to ensure optimum performance and longevity.
All Bluefin Led lights are water tested so please be aware there may be moisture present on the light.
If you have ordered the Aluminium (A)option please be aware that these have been Hard PTFE
Anodised to form a corrosion resistant coating. Please take care not to damage this coating when
installing the light.
Please ensure that your product is installed as per our instructions below, failure to do so may
invalidate your warranty.
Specs: electrical/fuse ratings
Voltage Current Fuse rating
Piranha P6N 12v 12V 12v 3.5 amp 5amp
Piranha P6N 24v 24V 24v 1.8 amp 3amp
Piranha P6CC 12/24V ONLY 12v4 amp 24v2 amp 8amp
Warnings:

Do not attempt to install the lights whilst the boat is in the water.

Ensure that the correct voltage is used for the light.

Ensure that an in line fuse is installed with the correct fuse rating per the light installed.

Ensure that use the Screws provided ( failure to do so will invalidate your warranty ).

Ensure all connections are made water tight.

Do not remove the Inline Moisture Guard.

Do not hold the light by the cable.

Do not use abrasives on the lenses.

Do not look directly into the light at close proximity
Tools required for installation:

2.5mm(3/32”) drill bit

15mm(19/32”) drill bit

Drill

Posi head hand screwdriver

Marine sealant 3M 4200 or equivalent
Installation: