![background image](http://html1.mh-extra.com/html/blue-robotics/lumen-light-r2/lumen-light-r2_manual_2776272001.webp)
7/31/2018
Lumen Light R2
http://docs.bluerobotics.com/lumen-r2/
1/6
Lumen Light R2
Introduction
This page is the most recent
Lumen
documentation page. If you have an older
Lumen
Light, you may wish to refer to the
archived documentation page:
Light R1 (Retired July 2018) (http://docs.bluerobotics.com/lumen/).
The
Lumen
Light is a sealed LED light which can supply up to 1500 lumens at depths of up to 950 meters. The
Lumen
Light can be
smoothly dimmed with a servo PWM signal or simply turned on/o with a switch. Up to six lights can be daisy-chained together
and controlled with a single signal, requiring only one penetration into a watertight enclosure.
Quick Start (on/o with no PWM signal source)
1. Connect the power wires to a power source
Red: +10-48 volts
Black: Ground
2. Connect the yellow signal wire to the the power wire directly or through a switch to turn on to full brightness
Quick Start (dimming with PWM signal)
1. Connect the signal wire to the appropriate microcontroller pin
Yellow: PWM (3-48 volts)
2. Connect the power wires to a power source
Red: +10-48 volts
Black: Ground
3. Provide a servo PWM pulse from 1100 μs (o ) to 1900 μs (brightest)
Speci cations
Speci cation Table
For further information please see the Cree XLamp MK-R LED Data Sheet
(http://www.cree.com/~/media/Files/Cree/LED%20Components%20and%20Modules/XLamp/Data%20and%20Binning/XLampMKR.pdf).
The speci c LED model used is MKRAWT-00-0000-0B00H4051.
Electrical
Item
Value
Supply Voltage (V )
7 - 48 volts
in