*CAUTION*
If you are not familiar with construction, hardware or the use of tools, please use a qualified general contractor to install.
Improper installation may cause injury.
Safety First:
Before using the hammock stand canopy, inspect your hammock stand canopy, hardware, installation points and objects
supporting your hammock stand canopy for wear or weakness. Make sure there is no excessive rust in the hanging hardware. Proceed
carefully and take your time installing it. The hammock stand canopy is not a playground swing or a trampoline. Misuse or rough play
may result in falls and may wear out your hammock stand canopy and hardware prematurely. Small children should be supervised when
using the hammock stand canopy. (For hammock only safety, please refer to the instructions that came with your hammock.)
PRODUCT WARRANTY
IMPORTANT
All Bliss Hammock products are guaranteed against manufacturing defects for 1 full year
from the date of purchase. Damage caused by the environment, improper use, or improper
care and maintenance is not covered
*Guarantee excludes clearance/closeout items, non-retail, private sales, and auction
website sales.
Please Note:
Hammock Stand
Canopy is only compatible with
stands similar to this illustration.
It is
NOT
recommended that the canopy be left unattended especially on windy or inclement
days. When canopy is not in use, please remove and store canopy to help prevent any
damage that wind may cause.
HAMMOCK STAND CANOPY
NOTE: Hammock, Hammock Stand & “Z” Hook NOT included
(Hammock Stand NOT included)
Bent Steel Tube
Bent Steel Tube
“Z” Hook
(Included only with your Hammock Stand)
Canopy with Tethering Ropes
NOTE: One is extra
Hook Screw
Nut
Package Contents
Make sure all parts are present & place
them side by side for easy identification.
x1
x2
x3
x2
x2
PART
QTY
ASSEMBLY INSTRUCTIONS
Step 1
Using a flathead screwdriver, remove the end cap of
the top of each pole of your hammock stand.
Step 2
Attach the Bent Steel Tube to the opening of
hammock stand. Then hook in the “Z” hook into hole
to lock the tubing together.
Step 3
Screw in hook onto top part of Bent Steel Tube.
Step 4
On each end of the Canopy, insert the Plastic Flexible
Pole on each side where there is a small pocket.
