![background image](http://html.mh-extra.com/html/blain-hydraulics/ev40/ev40_quick-start-manual_2768405001.webp)
www.blain.de
Pfaffenstr. 1, 74078 Heilbronn
+49 7131 28 210
1)
Wiring check
How?
Check
if wirings for sensors, drive
and the lift controller are done according to the descriptions in
the EV40 manual.
2)
Drive initialization
•
Make sure that
A1-01
(Access level selection) is set to
2,
•
Verify
H5-01
(Modbus communication address) is set to “
1F
”,
•
Change
H5-02
(Communication speed) to “
8
” (115.2kbps),
•
Power the drive off and on again to activate the setting (wait 3 minutes before re-powering). This will allow
the
Pro-Hydro
card to communicate with the drive,
•
Verify that 10 seconds after re-powering the drive the diagnostic LED on the
Pro-Hydro
card starts blinking
GREEN
at 1 second intervals
– See Section 3 and 5 in EV40 Manual when LED blinks
RED
.
After completing
“Initialization” phase further drive access is not necessary!
3)
Switching on Wi-Fi communication
How?
Place the
Wi-Fi
jumper correctly on the
Pro-Hydro
card (The jumper pins are located on the top-
left corner of the Pro-Hydro card, see Section 3.5.1 in the EV40 Manual).
Wi-Fi
is
ENABLED
when the two
pins are
not connected
.
Wi-Fi
is
DISABLED
when the jumper is connecting the two pins.
4)
Connecting your device to Pro-Hydro card
How?
To connect your device (eg. mobile phone) to the
Pro-Hydro
card use following name of
Wi-Fi
network (SSID) and password:-
Wi-Fi network (SSID)
Pro-Hydro
Password
Pro-Hydro
Alternatively, you can scan the QR code on the
left.
in the address bar of your browser or
scan the QR code on the
right
.
5)
Checking status menu & Sensor readings
How?
When
Wi-Fi
connection is done successfully, STATUS menu appears on
the smart phone. Check whether pressure and temperature readings are there and
correct. If sensor readings are not correct see Section 3 and 5 in EV40 Manual.
6)
Opening the Main Menu
How?
Touch on the top left indicator
and turn the switch
on from the open menu. Enter the
PIN Code 1111 and press OK. The Main Menu opens. Select
SYSTEM
option and change Unit and Language
preferences when necessary.
EV40 Quick Start Guide
Charge your mobile before proceeding!