REMOTE STOP VEHICLE
1. Press & hold the “START” button for 4 seconds.
2. Park lights will flash and vehicle shuts down.
Note: Pressing on brake pedal will also stop the engine
QUICK STOP MODE
(not available on some vehicles)
1. While vehicle is running with key, press & release the START button.
2. Park lights will turn “ON”. Turn ignition “OFF” and remove key.
3. Vehicle continues to run for 15 minutes, allowing you to run quick errands.
4. When you return, follow “WHEN READY TO DRIVE” procedure.
REMOTE START VEHICLE
1. Press & release the “START” button
2. Park lights will flash to confirm that remote start
command has been received
3. Vehicle’s engine will start.
4. Park lights will remain “ON” while engine is running
5. Follow “When ready to Drive” procedure below.
6. Vehicle will run for 15 minutes and shut down.
*
start
REMOTE RUNTIME EXTENSION
1. While vehicle is running with remote start, press & release the “START”
button to reset the timer and extend the runtime.
2. Park lights flash 1 time to confirm the extension of runtime
(15 min timer restarts).
Condition #1
Advice
Parking lights flash 3 times and vehicle does not proceed to start...
The system is in “Service Mode” (see Service Mode procedure)
Vehicle’s starter engages but engine does not start.
Parking lights flash 4-7 times and vehicle does not proceed to start...
Contact customer service/tech support for assistance.
Condition#2
Condition#3
Advice
REMOTE START
BC-1165/8
BC-1170/2/5
/
/
Date of Purchase/Installation
SERIAL NO.
1 1
OWNER’S MANUAL
Keep this manual inside vehicle for future reference and warranty claims.
installed by:
1 1
B C
Integrated Remote Start System
Technical Support:
[email protected]
Product Information:
www.blackcatsecurity.com
