INSTALLATION GUIDE
ROMAN BATTERY-OPERATED BLIND
Please Note: These instructions should be read thoroughly before installing.
This is a guide to assist in the installation and care of your blinds. Betta Blinds & Awnings does not guarantee the
accuracy of the information contained in this guide. We recommend an experienced expert installer to rely upon their
own skills. This is based on general knowledge concerning the assembly, materials and working process of the
blinds, which is known to us at the time of printing this guide, consequently, is subject to change and Betta Blinds &
Awnings specifically reserves the right to change this guide without notification.
We recommend the use of the following Tools: Steel measuring tape, Carpenter’s level, Power or battery drill & bits,
Flat blade and Phillips head screwdrivers
The following should be included for each Roman Blind ordered:
Installation brackets
(number of brackets is based on 200mm from each end plus 1 bracket per 800mm based on track width)
Installation gloves
When installing and handling fabric blinds, clean soft cotton gloves
(or soft vinyl gloves supplied)
must be worn to avoid
marking the fabrics.
Since different screws are required to suit different fixing applications, we do not supply screws. Please ensure you use the
correct screws for mounting to the desired application, for example Gyprock, timber, concrete, brick, steel or aluminium.
The most important procedure in installing these blinds is to be sure that the correct anchorage method has been
used so that the mounting area (i.e. wall or architrave) is able to support the weight of the blind and its operation
.
Brick or Rendered Surfaces Warning:
Make sure drilling is no closer than 25mm from edge of surfaces as the brick or
render may chip or break out.
INSTALLATION
1.
Check the marked width and drop sizes as indicated on the packaging against your original order.
2.
Each blind is marked to indicate the room location, as per your order form, to assist in establishing the correct fitting location
of multiple blind orders.
3.
If all is correct layout the blinds at their location and remove protective packaging.
4.
Remove the supplied installation brackets from their packaging.
5.
Since different screws are required to suit different fixing applications, we do not supply screws. Please ensure you use the
correct screws for mounting to the desired application, for example Gyprock, timber, concrete, brick, steel or aluminium
6.
The most important procedure in installing these blinds is to be sure that the correct anchorage method has been
used so that the mounting area (i.e. wall or architrave) is able to support the weight of the blind and its operation
.
7.
Ensure the blind has brackets to suit the application, either face fix or reveal.
8.
Level mounting is critical to the correct operation of the blind (use a spirit level).
9.
Fix the required brackets in the necessary positions of equal spacing to accommodate load bearing distribution. (200mm
from each end plus 1 bracket per 800mm based on track width)
10.
Betta Blinds supplies mounting brackets only, and where appropriate the child safety devices.
11.
Once the brackets have been installed and levels checked the blind is ready to be installed into the brackets as above photo
shows
