1/6
09/2015
Blind insert comfort
Blind insert comfort
Order no.: 8522 11 0x
Operating instructions
1. Safety instructions
Electrical equipment may only be installed and assembled by a qualified electrician in
accordance with the relevant installation standards, guidelines, regulations, directives,
safety and accident prevention regulations of the country.
Failure to comply with these instructions may result in damage to the device, fire or other
hazards.
Hazard due to electric shock. Disconnect before working on the device. Take into
account all circuit breakers that supply dangerous voltages to the device.
Hazard due to electric shock. The device is not suited for safe disconnection of the
mains supply.
Hazard due to electric shock. Do not operate device without application module.
If several drives should be connected in parallel to one output, it is mandatory to observe
the manufacturer's data; use a cut-off relay where required. Motors could be destroyed.
Use blind drives with mechanical or electrical final position switches only. Check final
position switches for correct adjustment. Observe motor manufacturer's data. The device
can be damaged.
Use blind push-buttons only for extension unit operation. The use of blind push-buttons
can cause malfunctions.
Risk of injury. Use the device to control blind and shutter drives or awnings only. Do not
switch any other loads.
Observe the motor manufacturer's data regarding change-over time and max.
switch-on time (ED).
Do not lay control lines in parallel to the motor lines (danger of coupling).
These instructions are an integral component of the product and must be retained by the
end user.
