200686_4
Page 1
1471 Electric Heater
User instructions for LED effect 2kw Heater
These instructions should be read carefully and retained for future reference
Important Notes
This product is only suitable for well insulated spaces or occasional use
Do not use this appliance as a primary heat source
This heater must not be located immediately below a fixed socket outlet.
Do not use the heater in the immediate surrounds of a bath, a shower, or a swimming pool.
Do not cover this heater, or obstruct the air inlet or outlet, otherwise there is a risk of
overheating.
Do not use outdoors
The heater must be cooled down completely before any maintenance
After unpacking, please make sure that the appliance is intact, with no signs of damage caused by
transport. If in doubt, do not use the appliance and contact the Service Centre.
During normal operation this appliance will emit noise from the internal fan unit.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Children should be supervised to ensure that they do not play with the appliance or handset
Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3
years and less than 8 years shall only switch on / off the appliance provided that it has been placed or
installed in its intended normal operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3
years and less than 8 years shall not plug in, regulate and clean the appliance or perform user
maintenance.
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning
and user maintenance shall not be made by children without supervision
Some parts of this product can become very hot and cause burns. Particular attention has to be given
where children and vulnerable people are in the vicinity.
Ensure that furniture, curtains and other combustible materials are positioned no closer that 1m from the
front of the fire.
Do not run cord under carpeting, do not cover cord with throw rugs, runners or the like. Arrange cord away
from traffic areas and where it will not be tripped over.
Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause
electric shock, fire or damage the appliance
Do not block air intakes or exhaust openings in any manner
Do not use on soft surfaces such as a bed, where openings may become blocked
If this fire is supplied through an extension cable, please ensure that it is the only appliance plugged into
the extension and that the instructions for the extension cable / reel are followed.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance
must not be supplied through an external switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
This appliance must be positioned so that the plug / fused spur is accessible
In the event of a fault please disconnect the fire from the mains supply
Warning: This appliance must be earthed.
The wires in the mains lead connected to this appliance are coloured in accordance with the following code:
GREEN and YELLOW
Earth
BLUE
Neutral
BROWN
Live
As the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol or coloured Green or Green and Yellow. The wire which is coloured
Blue must be connected to the terminal which is marked with the letter N or coloured Black. The wire which is
coloured Brown must be connected to the terminal which is marked with letter L or coloured Red.
