AXL2 (80-280W)
INSTALLATION INSTRUCTIONS
800.533.3948 • www.barronltg.com
Mounting Preparation
Slip Fitter
(fits up to 2 3/8” OD)
1. Separate the slip-fitter from the knuckle by removing the adjustment bolt with a hex wrench (provided by
others) (Fig. 1).
2. Feed wire leads from the AXL2 through the knuckle and attached the knuckle to the head (Fig. 2).
3. Feed wire leads through the slip-fitter and then attach the slip-fitter to the knuckle (Fig. 3).
4. Electrical connections should be made at this time (see
Wiring
section).
5. Install the slip-fitter on the pole and secure with screws.
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
•
DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
Fig. 1
Fig. 2
Fig. 3
20070138 REV 1 P-5 - 2/19
1
