TP600
Quick Reference Guide
‘the name behind the big brands’
Start up
When the spa is switched on, a strat up sequence of numbers will appear on the display. If no button is pressed, LINK will appear after the
start up sequence. Press any button to link the panel with the system.
The spa will enter Priming Mode. After Linking, press the Jets Button(s)
to turn the pumps on and off to verify that all air is purged
from the plumbing, particularly the plumbing associated with the heater. If the spa has an Eco Filtration Pump, the light
Button turns
the Circ Pump on and off during Priming Mode. Priming Mode will end automatically in 4 minutes. Pressing Temperature Button Down
t
will exit Priming Mode manually. When Priming Mode ends, Pump1 low will start if no Circ Pump is present, however the water temperature
will not appear for a minute or so. Once the water temperature is recognized by the system, and if it is below the Set Temperature, the
heater will start.
Default Pre-Set
The default preset temperature is 38C in Ready Mode
Warm. The Filter Cycles are 8:00 to 12:00 and 20:00 to 0:00
Temperature Adjustment
TP600 touch pad has the Up
▲
and Down
t
buttons as Temperature Buttons. While TP400 only has a single Temperature Button.
Press the Warm Button
once and the current Set Temperature will begin to flash on the LCD. (The Set Temperature and the actual
water temperature are often different.) While the numbers are flashing, press the Warm Button again to change the Set Temperature. Press-
and-hold for faster adjustment. After the new Set Temperature stops flashing, in about 10 seconds, the actual temperature is displayed
again and the new Set Temperature is programmed. The spa will now heat to the new Set Temperature as needed.
Set the Time-of-day
Press
, then repeatedly press
until ‘TIME’ appears in the LCD. Press
to select the hour and press
to set and move
to minutes. Press
to set the minute. Press
or wait for 10 seconds to go back to the Main Screen.
Dual Temperature Ranges (High Vs Low)
This system incorporates two temperature range settings with independent set temperatures. The High Range is indicated in the display
Range up
▲
. The Low Range is indicated in the display Range down
t
.
To change the Temperature Range, press
then
, and press
to toggle the Range arrows in the LCD. Press
or wait
for 10 seconds to go back to the Main Screen.
These ranges can be used for various reasons, with a common use being a ‘ready to use’ setting Vs a ‘vacation’ setting. Each range
maintains its own set temperature as set by the user. This way, when a range is chosen, the spa will heat to the set temperature associated
with that range.
High Range can be set between 26.5°C to 40°C.
Low Range can be set between 10°C to 36°C.
Setting Ready and Rest Mode
READY mode will circulate water every 30 minutes in order to maintain a constant water temperature, heat as needed, and refresh the
temperature display.
JETS
AUX
LIGHT HEAT
TP600
