S2-AGW10000K01
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD, AND RECEIPT.
Page 2
PARTS LIST
DESCRIPTION
ORDER PART # QTY
1
A
B
C
D
E
F
G
1
HEX BOLT DRIVER
LEFT LEG
HW0004
HW0006
FOOT CAP
FACTORY ASSEMBLY
1
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Ø6.5 X 1.0 MM
WASHER
FC0607
1/4" X 35 MM BOLT
HW0142
6
CHAIR FRAME
1
RIGHT LEG
6
Step 1:
Do not
attempt assembly if any parts are missing or damaged.
Step 2:
Hand tighten only 2-3 turns.
Step 3:
Do not over tighten
Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts packed in the carton against the parts list.
If you are missing any parts or unsure how to proceed with assembly, call our Customer Service Center at 1-800-416-3511.
Attach the chair frame to the left leg by using three bolts and washers as shown in the diagram. Guide the bolts through the holes
in the chair frame into the pre-drilled holes in the left leg.
After making any necessary adjustments to the alignment of the parts, use the hex bolt driver to tighten all bolts. Repeat until all
bolts are tight.
. Over tightening may strip bolts. Cover bolts with bolt covers provided. Your chair is now
ready for use. If you have any questions, please call our Customer Service Center at 1-800-416-3511.
Repeat for the right leg.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered under
our warranty. Please read all instructions carefully before assembly. If you have any questions regarding your assembly, call our
Customer Service Center at 1-800-416-3511.
BOLT COVER
HW0105
2
B
D
E
E
D
A
C
D
E
F
AK1638
AK1639
AK1640
