E6L RAM Reseating and Cable Rework
1
E6L RAM Reseating and Cable Rework
Some early revision E6L Engines can have difficulty booting up because internal cabling is pushing on the innermost RAM modules or
because RAM has become unseated. Although the cable routing has been corrected in manufacturing for some time, some E6L Engines
may have shipped before the corrective action. Follow the procedures in this document to check cable routing and to reseat RAM, if nec-
essary.
• All users should check and, if necessary, adjust incorrect cabling.
• Any users experiencing difficulty booting their E6L Engine should also check and, if necessary, reseat RAM (see “Troubleshoot-
ing” on page 10 to determine if you should reseat RAM).
Required Materials
• Anti-Static wrist strap (not included)
• Cutters (for cutting cable ties)
• Replacement cable ties
• 12-inch long Phillips #2 screwdriver (not included). Magnetic tip recommended.
• Table or other clean, flat work surface
• Recommended: E6L Engine System Restore USB drive (not included)
Removing the E6L Engine Core
To remove the E6L engine core
1
Put on your anti-static wrist band and configure according to its instructions.
2
Shut down your system, and disconnect any cables connected to your E6L engine.
3
Place your E6L on a table or other flat surface that provides enough room for the E6L engine core to be removed comfortably. Make
sure your surface is clear of any debris.
4
On the back of the E6L, loosen the four thumbscrews that secure the core to the engine chassis.
Figure 1. Four thumbscrews on the back of the E6L
© 2018 Avid Technology, Inc
9329-65996-00 REV A
