TECHNICAL SPECIFICATIONS
Document version:
2.10 - November 21, 2019
Valid for products:
Ave325,Avee335, Avee340
Software version 2.10
Connector headphone
Connector headphone
Bose
™
QC25
™
& QC35
™
2.5mm four pin audio
Sony
™
WH-1000XM3
™
3.5mm four pin audio
Connector AC interface cable
USB C
Bias voltage accepted
9-16VDC
Microphone type
Noise reduction
Microphone output signal
0.7 V RMS @ 1khz / 74dB SPL
Adjustable in 6 steps 20-100%
Maximum level is 1.5V RMS
Minimum level is 0.2V RMS
Speaker audio level
Adjustable in 6 steps / 10-100%
Start-up mode speaker
Configurable
Maximum volume on restart is default
setting.
Mono/stereo detection
Mono, automatic or Stereo always
Automatic is (default setting)
Configurable with the Avee BlueLink and
from the Avee add-on.
Stereo detection signal level
0.2V RMS
Adjustable using the Avee BlueLink
Firmware
Upgradeable with the Avee BlueLink
FACTORY SETTINGS
Start-up mode speaker
Maximum volume on restart.
Microphone output signal
0.7V RMS (step 4)
Mono & stereo setting:
Automatic
DISCLAIMER
Avee is an unlicensed third-party accessory and is not affiliated with Bose
™
or
Sony
™
.
Bose
™
or Sony
™
does not approve or endorse the products manufactured by Avee.
The Avee Aviation Microphone add-on
Setup Instructions & User Guide
Follow the instructions in this user guide to install the Avee add-on to your
headphones.
Step 1:
Using the cleaning wipe supplied,
clean the base of your headphones including
the area surrounding the input jack. Ensure
that you remove any residue that is adhered
to the headphones. Let dry.
Step 2:
Remove the adhesive strip protective backing from the add-on
magnetic strip
.
The magnetic adhesive strip has the adhesive side facing the headphone, and
two magnets facing the Avee add-
on.
This feature enables the Avee to
be easily detached & attached
from the headphone.
Step 3:
Guide the add-on to the base of the left headphone and firmly press
it in place for minimum 30 seconds. Once
attached,
carefully unplug it to reveal the
adhesive magnetic tape applied to the
headphones
. Press firmly on the tape to
ensure all edges of the tape have adhered to
the headphones.
