R22 Dual Camera
Important Notes ©
Congratulations on purchasing a R22 Dual Camera.
Please take time to read these notes in conjunction with your User Manual
OnSite Cameras have pre-set your new dash camera for you, see below for settings.
Getting Started
Insert the micro SD Memory Card
Insert the memory card into the micro SD slot on the side of the dash camera. Your camera comes with a micro
SD card and needs to be inserted in the slot at the top of the rear vision mirror device.
Attaching the dash camera to your rear vision mirror
Using the rubber straps that come with the camera strap the rear vision device to your rear vision mirror with
the camera at the back of the device facing forward. The connection for the rear camera is at the top of the rear
vision device and then ensure the cables are run to the back of your vehicle in a safe way to ensure they don’t
interfere with any parts of the vehicle. It is suggested you get an Auto Electrician to fit the rear camera and
ensure the cables are neatly tucked away in the vehicle. Use the sticker that is attached to the rear camera to
stick the camera onto the rear window with the camera facing back. When fitted correctly the dash camera
should not obscure the driver’s vision. Each State has their own legal requirements for where dash cameras can
be installed please check these laws before installing and ensure that your dash cam complies. (It is illegal and
dangerous to move or operate your dash camera whilst driving).
To power the dash camera
Insert the power lead into the dash camera via the mini USB port on the top of the rear vision device and plug
the power lead into the cigarette lighter. WARNING:
Do not use USB cables in your vehicle to power the dash
camera, as this will result in your dash camera receiving too much voltage and will void your warranty. If you
have chosen to hardwire the dash camera, ensure it is an approved hardwire kit supplied by OnSite Cameras
only, and all components are tested thoroughly, by an Auto Electrician, before installation. The circuit for the
hardwire kit should be the same as the cigarette lighter circuit (coming on and off with the vehicle’s power and
does not stay powered 24/7). Any electrical work performed on the vehicle such as hardwire installation is done
at your own risk and OnSite Cameras cannot be held responsible for any installation costs or additional costs
that may be incurred after a fault or failure of dash camera, mount, hardwire kit, or car electrics. We strongly
recommend that you hire a fully qualified, insured, and experienced Auto Electrician to install the hardwire kit
for you.
The dash camera is ONLY 5V/1A, and using a power lead not supplied by OnSite Cameras will void your
warranty.
Once the dash camera is powered both cameras will automatically come on and start recording.
Format the micro SD memory card
You must format your micro SD memory card in the dash camera prior to its first use. To format the SD card
press the button to the left of the “M” button at the bottom of the rear vision device. You then need to arrow
through the option to the “Format” option where you will be able to format the SD card. Press OK to start
recording again. We recommend you format your micro SD memory card at least once a month. This reduces
the chance of SD card errors which can cause operational malfunctions with the dash camera.
WARNING:
All
files are permanently deleted when your micro SD card is formatted. Please ensure you have downloaded and
saved any/all files that you require prior to formatting, this function cannot be undone.
