7030-MNT-19
Installation Guide
0511563-01
|
April 2014
1
This mounting kit allows mounting the 7030 controller in a two-post 19-inch Telco rack.
Required Tools and Equipment
The following tools and equipment are required for installing a 7030 controller:
Mounting Bracket (x2) (included in the kit)
Screws for mounting bracket (x8): M3 x 6.5 mm Phillips Flat Head Screws (included in the kit)
Screws for system rack mount (4x): M6 x 15 mm Phillips Pan Head Screws (included in the kit)
Suitable Screwdrivers for all screw types provided in the box (not included in the kit)
Installation Steps
To install a 7030 controller into a two-post 19-inch Telco rack:
1. Place the mounting bracket over the mounting holes on the controller (see
2. Secure the bracket to the controller using the eight screws for the mount bracket (four per bracket) and
a suitable screwdriver.
Figure 1
Rack Mount Brackets
3. Mount the controller within your organization’s rack system using the four screws for system rack
mount (two per bracket) and a suitable screwdriver (see
!
CAUTION
Each 7030 controller should have its own mounting equipment. Do not place other networking equipment directly
on top of a mounted 7030 controller. Failure to do so can damage the device.
Some racks require screws that differ from those included with the 7030 controller. Ensure that you have the
correct screws before installing the 7030 controller.
