![background image](http://html1.mh-extra.com/html/armerah/ego-mini/ego-mini_quick-manual_2973768001.webp)
You must be eighteen (18) years of age to purchase any of our electronic
cigarette products.
Complies with relevant European standards.
Armerah eGo Mini Protank Clearomiser with Replaceable Coil
General Instructions and Guidance
Before fitting the clearomiser to a battery you should first clean inside the bottom of the clearomiser and the top of the
battery. Gently use rolled up paper tissue or a lint free cleaning cloth to clear any stray e-liquid from the electrical contact
areas. A quick clean can be achieved by blowing sharply into both devices. Then screw the clearomiser into the battery in a
clockwise direction, DO NOT OVER-TIGHTEN.
To remove the clearomiser from a battery, first grip the metal ring at the bottom of the clearomiser just above the battery
button and unscrew the battery in an anticlockwise direction. Do not grip the tank body as this might cause it to unscrew
from its base causing liquid spillage.
Due to natural efficiency loss over time, the vapour production or the flavour quality of your vape will eventually
deteriorate. When this happens you should replace the coil or clean the device as described below.
Refilling
Refill once the tank is down to approximately 10 to 20% full. This is accomplished from the bottom of the clearomiser and
so it must first be removed from the battery as directed above. Then unscrew and remove the base in an anticlockwise
direction being careful not to displace the silicone sealing rings, put the base and coil assembly carefully to the side. Now
hold the clearomiser tank at an angle of approximately 45 degrees with the mouthpiece pointing downwards. Refill slowly
through the bottom up to the top of the central tube by placing the spout tube of your e-liquid bottle down the inside of
the tank and gently squeezing. The level can be seen through the tank glass, take care not to spill the e-liquid into the
central tube.
Replace the base securely then blow gently down the mouthpiece to clear any spilled liquid from the central tube. Blow
sharply into the bottom of the atomiser and the top of the battery to clear any stray e-liquid from the electrical contact
areas or clean gently using a paper power or cloth. Then screw the clearomiser back onto the battery in a clockwise
direction, DO NOT OVER-TIGHTEN. We recommend you wait 10 to 15 minutes before use after first filling a new device to
ensure the e-liquid has soaked thoroughly into the wicks and coil.
Maintenance, Replacing Coils and Cleaning
If the quality of your vape deteriorates then first check that the clearomiser is not near to empty (less than 10% full) and
that the battery has not discharged. If not then the coil should be removed and cleaned or replaced.
To replace the coil you must first remove the clearomiser from the battery. Grip
the metal ring at the bottom of the clearomiser just above the battery button
and unscrew the battery in an anticlockwise direction. Now hold the clearomiser
tank upside down in one hand then grip the metal base ring in your other hand
and unscrew it in an anticlockwise direction until it has separated from the tank.
Unscrew the coil head from the base and replace with a new coil. Be careful not
to spill any liquid that is left in the tank. Refill as normal if necessary then screw
the base and coil assembly back into the tank in a clockwise direction and tighten
securely via the base ring. Clean thoroughly before refitting to the battery.
To clean your clearomiser first remove it from your battery, then remove the base ring and coil as described above and
empty any remaining e-liquid. Rinse all components in hand hot (not boiling) water. Take care not to displace the silicone
sealing ring fitted to the base assembly. The components should then be left to dry thoroughly for 24 hours before
reassembling and refilling.