Telescoping pole extends upward from
17 inches to 29 inches.
Compatibility:
Fits smart phones with cases weighing
up to 2 pounds and measuring up to 4”
wide and 1/4”-20 compatible cameras.
IMPORTANT:
Do not overtighten ring. Overtightening
ring may damage threads on holder
and also make it difficult to adjust
holder.
3
2
Attach mount to surface by tightening C-clamp knob. Slide optional
rubber clamp boot onto the top of the mount’s clamp to prevent
scratching clamp surface if desired.
For thicker tables or desks, adjust the clamp bracket by using a Phillips
screwdriver to remove the screws from the top position and move
them to the bottom position.
Your Pro Stand Clamp Mount will arrive in four parts:
Clamp Pedestal with
Telescoping Pole
Overhead Arm
Assembly
25mm to 1/4”-20
Camera Bolt Adapter
(optional)
RV001WR-B
Attach overhead arm assembly to clamp pedestal by unscrewing the
collar at the top of the pole until the metal ball side of the overhead
arm assembly fits into the collar. Tighten collar clockwise to secure.
Unscrew tightening ring from holder. Place ring over the 17mm end of
mount then snap the holder onto the ball. Set to desired position, then
tighten ring.
SP25MMCAM
Assembled Mount
SP3RMPR0PL
SP3RMPR0PL
HD011-B
Tightening Ring
Tightening
Knob
Collar
Metal
Ball Side
Screws
Screws
Continued on page 2
CLAMPRV29
|
Arkon Pro Stand Clamp Mount for Phone or Cameras
HD011-B
Phone Holder
RV001WR-B
Clamp Bracket
C-Clamp Knob
C-Clamp
rev.091818
1
a
1
b
