![background image](http://html.mh-extra.com/html/aqualighter/30/30_quick-manual_2960065001.webp)
Types:
V frequency
Light temperature, K
Power, Watt
Luminous flux, Lum
Length, mm
Parameters:
Fig.1
1. LED illumination lamp AquaLighter 2
2. Driver current
3. Foot
mounting
4. Switch
AquaLighter 2 Illumination Lamp User Manual Guide
Dear Sir and Madam,
W
e thank you for choosing our product. We assure you that you will be
satisfied with the work of this illumination lamp. Please, study this User
Manual Guide before use in order to avoid problems connected to its usage.
Intended Use and Specifications of the Product
AquaLighter 2 LED illumination lamp is designed to
function
over the water
surface and is used for illumination of the freshwater aquariums. The
movable feet allow you to use the illumination lamp for aquariums of different
length. The source of illumination of the lamp
is
bright LEDs
produced by
CREE (USA).
The p
ower supply is by current LED drivers. The illumination
lamp can be used for aquariums with
a wall
thickness of up to 12 mm.
Technical characteristic
Ingress protection rating - IP67
Safety Usage Rules
The device you have purchased is manufactured in compliance with the
norms applicable on the territory of Ukraine and
the
European Union. For
long lasting and safe usage, please do study the safety rules listed below:
1. This device is designed to be used only within indoor areas and only
for
its
intended use.
2.
The voltage
rating of the power supply system has to be exactly the same as
the voltage rating indicated on the device.
3.
This lamp is
protected against moisture (degree of protection IP67). The
device can withstand short-term immersion in water without loss of capacity.
In
the
case of contact of the device with water
,
wipe the
water off the
surface
and wait until
the device is
dry before operating.
5. It is forbidden to repair or change
the
electrical cord as well as install extra
elements on it. If
the
electrical cord of the device was damaged
,
contact
technical support.
6. Before you switch on the illumination lamp, please make sure it is fixed
safely on the walls of
the
aquarium.
Preparation for Work
Fasten
the feet on the body of the illumination lamp as shown
in
Fig. 1.
To mount the lamp under
the
aquarium cover
,
fix it with special fittings
(supplied) as shown
i
n Fig. 2.
Assembly and Startup
Place the illumination lamp on the aquarium, moving the feet along the body
of the device until you reach the necessary length.
Having fixed
the
illumination lamp safely on the walls of
the
aquarium, plug in the plug of the
power supply block into the socket driver current on the illumination lamp.
The device is ready to use. Connect the power supply block to the power
supply system. Turn
on
the switch on the body current driver.
Maintenance
The device does not require any special maintenance. If necessary, clean
off
residues resting on
the body of the illumination lamp with the help of soft
tissue or a sponge.
Dismantling and Utilization
You cannot dispose of electrical appliances that are out of order into regular
garbage. Proper selection, collection
,
and utilization of this type of waste will
contribute to preserving the valuable
resources
of
the
environment.
The user
is held liable for delivery of the used equipment to the special
collecting point, where it will be accepted free of charge.
Warranty
The manufacturer
gives a warranty of 24 months
from
the purchase date.
The warranty covers damages that appeared due to the fault of
the
manufacturer, i.e.
,
material defects
,
etc. The warranty does not cover
damages that appeared due to
the
improper or unintended use of illumination
lamp.
Attention! Any trials to change the structure of the device
,
or dismantling of
the device
,
that fall out of the scope of regular intended use or maintenance
lead to loss of warranty obligations.
In case improper functioning of the device is detected, contact technical
support. The warranty shall be considered valid if the date of production
indicated on the product coincides with the date of production in the warranty
paper. The present warranty conditions do not exclude, limit
,
or cease the
rights of the buyer granted by the applicable legislation of the country where
the sale was made.
Fig.2
www.
aqualighter
.com
YOUR
LED LAMP
FOR AQUARIUM
Aquarium comes alive!
30 cm
60
cm
9
0 cm
11
22
1080
2160
300
600
6500
-7000
30
60
90
AC 110~230V (50-60Hz) / DC~ 48V, 3
8
0mA
33
3240
90
0