![background image](http://html1.mh-extra.com/html/aquacal/hp9/hp9_quick-start-manual_2959566001.webp)
A
Wake up heat pump
The display's backlight will be off when the heat
pump is in sleep mode. To wake up the heat pump,
slowly slide a finger across the buttons.
l
The display will illuminate.
l
The message "KEYPAD UNLOCKED" will
briefly appear.
l
Then the water temperature and mode will
display.
B
Choose what you want the heat pump to do
C
Set a desired temperature (setpoint) for the water
Where are the controls?
The display panel is located in a door compartment on the front of the heat pump. This
compartment is designed to protect the display against harsh weather. It can also be padlocked for
extra security.
l
Press the
bottom
of
the panel to open the
display panel door.
l
To close, push the
display panel up.
Then press the
bottom
of the panel
in until a clicking
noise is heard.
What's on the display
Buttons
Description
Slowly slide a finger across the buttons from left to right to disable the sleep mode.
Sleep mode will automatically reactivate after three minutes have passed.
Select either the pool or the spa thermostat.
Enter the user menu for heat pump options.
Used to increase temperature set point and navigate through menu options.
Used to decrease temperature set point and navigate through menu options.
Used to select the heat pump's operating mode. Also used to edit or confirm options
in a menu.
Indicators
Description
Heating
Red LED indicates the unit is heating the water.
Cooling
Blue LED indicates the unit is cooling the water.
When calling for heating or cooling, up to a three-minute delay may occur before the compressor
starts. The compressor must be operating before the indicator will illuminate.
Quick Start Guide
LTP0117 Rev. 1.03
- (project rel 7.02)