P/N: 02406
1
EN - USER MANUAL
Electric Scissor jack with remote and
repair KIT 3T 12V TUV
1. Screw socket
2. Screw
3. Jacking arms
4. Gearbox
5. DC Motor
6. Platform
7. Steering pilot
8. Fuse
SAFETY INSTRUCTIONS:
1. Read the instructions before working with the lift.
2. Do not move the car while the jack is running.
3. Do not overload the jack.
4.
Place the lift on a flat, hard surface.
5.
Do not touch the lift while it is in operation, putting your hand in
the operating lift may result in injury or damage to your health.
6.
When connecting the lift directly under the battery, pay attention
to the polarity, reverse polarity will damage the lift remote control.
7.
The jack is not designed for continuous operation, take care not to
overheat the engine.
8. Check that the maximum load on the cigarette lighter socket sup-
ply is not less than the power of the jack, if so, connect the jack
directly under the car battery.
9. IF YOU PUT YOUR HAND IN THE CLOSING JACK, YOU RISK CUT-
TING OFF YOUR FINGER.
OPERATION:
1.
Park the car on a flat, stable surface with a slope of not more than
6 degrees.
2.
Apply the parking brake
3. Place wedges under the wheels to prevent the car from moving
4. Place the jack in the designated area of the car chassis
5.
You can connect the power supply in two ways:
- Under the cigarette lighter socket, if its protection is higher than
12A
- Directly under the battery through an adapter, paying attention
to the polarity
6.
Start lifting the vehicle after making sure that the vehicle rests firm
-
ly on the jack. Lifting / lowering the vehicle is done by pressing / on
the remote control.
7.
After the vehicle is lifted, lower the vehicle onto the car supports.
NOTE: Do not work with the vehicle raised on the lift itself! The jack
is only for lifting the vehicle!
MAINTENANCE:
Clean the elevator with a dry cloth, periodically lubricate the elevator
screw to prevent it from seizing.
Replacing the fuse in the elevator plug:
Unscrew the tip of the plug and replace the fuse with a new one with
the same parameters
CAUTION!
If the jack cannot be lowered (e.g. no power supply), you can lower
the car manually using the included handle. The handle is mounted
on the elevator gearbox, so that you can lower the vehicle by turning
it anticlockwise.
TECHNICAL PARAMETERS:
•
Input voltage: DC 12V
•
Rate current: 13A
•
Rate power: 100W
EN
PL
ES
CZ
SK
1
2
3
4
5
6
7
8
7
