Your satisfaction with our products is very
important to us.
We would like to know what you like or dislike
about our products and what we can do to
make them even more beneficial to you.
Please give us your comments by calling our
Customer Service Department at the numbers
given. We value your comments and appreciate
your business. Thank you.
9VDC
200mA
OFF
ON
Page 1 2 3 4 5
ALERTMASTER
PERSONAL SIGNALER (AM-PX)
and
PERSONAL TACTILE
SIGNALER (AM-PXB)
OPERATING INSTRUCTIONS
(For units without external antenna)
VOICE (800) 874-3005 TTY (800) 772-2889
FAX (714) 897-4703
[email protected] www.ameriphone.com
®
The Alertmaster Personal Signaler (AM-PX)
and Personal Tactile Signaler (AM-PXB) use
an FCC approved receiver/transmitter, as
specified in Part 15 of the FCC Rules. Its
operation is subject to the following 2 conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
that may be received, including
interference that may cause undesired
operation.
FCC INFORMATION
To set Pager feature:
1. DIP switch positions 5, 6, 7 and 8
determine the pager ID of each unit.
2. Slide open the battery compartment and
locate the DIP switch inside the AM-PX.
3. Use a pen to move the DIP switches to
set up the Pager feature as follows:
• Leave all settings down
(off) for Pager ID #1
• Push #5 switch
up
to ON
position for Pager ID #2
• Push #6 switch
up
to ON
position for Pager ID #3
• Push #7 switch
up
to ON
position for Pager ID #4
• Push #8 switch
up
to ON
position for Pager ID #5
The Personal Signaler (AM-PX) and Personal
Tactile Signaler (AM-PXB) each come
installed with a 2.4 volt rechargeable NiCad
battery. It normally lasts 25-50 activations or
16 hours of continuous usage. If the
vibration is weak, recharge the unit with the
supplied adapter/charger.
Before the first use, charge the unit for at
least 8 hours.
PAGER SETTING (AM-PX)
BATTERY
6
Patents Pending ©AMERIPHONE, AM-PX/PXB 5220-1041
∆
4/02 M08398
5 6 7 8
ON
OFF
ON
OFF
5 6 7 8
ON
OFF
5 6 7 8
ON
OFF
5 6 7 8
ON
OFF
5 6 7 8
Should the difficulty persist, contact
Ameriphone or your authorized dealer
for assistance.
IN CASE OF DIFFICULTY
Symptom
Cause and Remedy
No power
The Unit is
turned off or
battery needs
recharging
It does not
The DIP Switches
activate when
may be incorrectly
the base unit
set. See "Channel
is triggered
Setting". Or, it may
be out of range.
The Alertmaster Notification System uses
radio signals to communicate between the
console unit and all its accessories. For the
Personal Signaler to activate, they all have
to be on the same "channel." A "DIP
Switch" is used for channel selection.
Your system and all the accessories have
been preset in the factory to a standard
channel setting. Under normal operating
conditions,
there is no adjustment
necessary
.
If your system encounters interference and
repeatedly activates by itself for no obvious
reason, maybe it’s being triggered by a
system nearby.
Change channel switch settings on all
components.
1. Unplug AC cord and locate DIP Switch
on the underside of the Alertmaster
base unit.
2. Slide open the battery compartment and
locate DIP Switch inside of the AM-PX/
AM-PXB.
3. Use a pen to change the DIP Switches to
a new matching setting.
4. Change the switch settings on each of
your other accessories (doorbell Remote
Receiver, etc.) to match the new switch
setting in the base unit. All settings must
be identical for the system to work. Switch
for AM-6000 is on the bottom, AM-7000
is on the back.
CHANNEL SETTING
1 2 3 4
ON
O
F
F
1 2 3 4
5 6 7 8
1 2 3 4
ON
5 6 7 8
1 2 3 4
ON
Base Unit
AM-PX
AM-PXB
Use a pen or pencil to
set DIP Switches to
match exactly
Pager ID
Channel Setting
1. Clip the receiver onto your belt. Slide
power switch to ON. It will alert you
within an 80-foot radius of the Alertmaster
base unit. Do not use the unit in the rain
or in the shower.
2. When the Alertmaster Notification System
is activated by any function(s), the
Signaler will come on for 24 seconds or
until it is reset or turned off.
3. To reset, either press the RESET button, or
slide the power switch to OFF then to ON:
•Phone - Vibrates two seconds,
stops for four seconds, and repeats.
•Door - Vibrates two seconds, stops
for two seconds, and repeats. This
function is also activated by the Door
Announcer (Model AM-DX).
•Clock/Paging
- Vibrates one
second, stops for two seconds,
and repeats. Master Paging also acti-
vates this icon and all other AM6000
components.
•Sound - Vibrates for one second,
stops for one second, and repeats.
This function is activated by the Baby
Sound Monitor (AM-BX).
•Alarm - Vibrates for one second,
stops for one second, and repeats.
This function is also activated by the
Audio Alarm Transmitter ( AM-AX).
•Sensor - Vibrates for one second,
stops for one second, vibrates for
one second, stops for two seconds,
and repeats. This function is also
activated by the Motion Sensor
(AM-SX).
3. AM-PXB OPERATIONS
When the Personal Tactile Signaler
(AM-PXB) is activated, press the control
buttons, one after another, until the
vibration becomes continuous. The button
that causes continuous vibration is the one
corresponding to the source of the alert.
OPERATIONS
FEATURE IDENTIFICATION
Battery
charger
jack
Power
switch
Control buttons
& raised letters
(AM-PXB) only
Light indicators
Battery door
(behind)
AM PXB
AM PX
Reset
Master
Paging
®
®
Ameriphone warrants the AM-PX/PXB against any defect in
workmanship or material, for a period of one year from the date
of purchase.
If the product is defective and returned within 30 days of
purchase, the unit will be replaced at the place of purchase
at no charge.
If it is returned after 30 days but within one year, Ameriphone
will repair or replace it at no charge. In repairing your
AM-PX/PXB, we may use new or reconditioned parts. If we elect
to replace your AM-PX/PXB, we may replace it with a new or
reconditioned product of the same or similar design. Repair or
replacement will be warranted for either 90 days or the
remaining time on the warranty period, whichever is longer.
When in need of warranty repair, please call our customer
service department at (800) 874-3005 (voice), (800) 772-2889
(TTY). They will help you process your return shipment. You must
prepay all shipping costs.
Implied warranties, including those of fitness for a particular
purpose and merchantability (unwritten warranty that the prod-
uct is fit for ordinary use), are limited to one year from date of
purchase. We will not pay for loss of time, inconvenience, loss
of use of your AM-PX/PXB or property damage caused by your
AM-PX/PXB or its failure to work, or any other incidental or
consequential damages. Some states do not allow limitations on
LIMITED WARRANTY
how long an implied warranty lasts or the exclusion of incidental
or consequential damages, so the above exclusions or imitations
may not apply to you.
We suggest you save the original package materials in the event
that you need to ship your AM-PX/PXB back. When shipping for
warranty repair, include your name, address, phone number,
proof of date of purchase and a description of the problem.
After repairing the product, we will ship it back to you at no
cost within the United States.
This warranty does not cover defects resulting from accidents,
damage while in transit to our service location, alterations,
unauthorized repair, failure to follow instructions, misuse, use
outside the United States or Canada, fire, flood and acts of
God.
®
Works with ALERTMASTER Product Series
®
