background image

Activate your account and device 

GL300 W

Go to

 www.americaloc.com

, select 

United States and click the 

Activate Now button.

Before using our products or installing a device, carefully read our legal terms which you can find at 

http://us.americaloc.com/legal_info.html .

Fill in the required information. The IMEI 

code can be found below the bar code 

that is printed on the back of your device. 

Your account will now be ready to use.

Go to 

www.americaloc.com

 and 

log in with the username and 

password established in the 

previous step.

Purchase one of our service plans by 

clicking on the 

Click to pay service

 button. 

A window will open to provide you with 

payment instructions.

Turn OFF and then ON the device after initial service payment.

   Your device already comes 

with a SIM card installed. 

Please do not remove the SIM card

1

3

2

4

5

Appearance

The 

POWER

 key is in the upper side of the device. 

POWER ON

:  Press the power key for 5 seconds. 

Check LEDs are ON before using

POWER OFF:

    Press the power key for 5 seconds, release 

the button and wait until the LEDs power off. It may take 

up to a minute for the device to power down. 

CHARGING

: Fully charge your device before using it for 

the first time. A full charge takes about 

8 hours. 

 

FUNCTION KEY: 

 You can configure notifications in your 

Americaloc’s account so every time this key is pressed 

an email will be sent to the subscribed email warning 

about this event.

Power key

Welcome to AMERICALOC

IMPORTANT:

 Your complete satisfaction is our first priority! If you have a problem or need assistance 

please contact us at 

[email protected]

. Rest assured we will find a solution for you. Our friendly, 

knowledgeable customer service representatives are standing by to explain our services and to assist 

you in getting the most from your GPS tracking service.

Your device's settings are optimized for vehicle tracking. Please reach out to our Support Team at 

[email protected]

 if you are tracking something other than a vehicle. We will gladly assist 

you with configuring the device for maximum performance and battery life. 

Function

 key

RED

 

(

POWER LED)

GREEN (MOBILE NETWORK LED)

BLUE (GPS ERROR LED)

Fast flash: Charging 

Slow flash: Low battery 

Dark: Normal behavior or Device OFF 

Solid: Charging completed 

Fast flash:  Searching for network 

Slow flash: Registered on network 

Dark: Device OFF 

1. How long does it take to activate my device after processing a payment?

Your device  will be active after the payment once you turn it off and turn it back on.

2. How does this technology work?

Your device reads data from satellites to find its location; it then uses mobile networks to  transmit its 

location to our servers. Your device needs both: mobile network and GPS signals to work.

3. Do I need to purchase or provide a SIM card?

No, we ship the device with the SIM card it needs to transmit data. That SIM card only works with this 

device.

4. Do I need to install the SIM card?

No, the card is already installed. Please do not remove it.

5. I can´t see my device’s location on the website. 

If your device is powered ON, there are 2 reasons for this problem:

• Poor mobile network signal: 

Your device may be in a zone with poor mobile data coverage. 

It will start transmitting again as soon as it gets into a better coverage zone. The device has an internal 

memory to store locations in those cases. That information will be transmitted as soon as the device can 

connect to the network again.

• Poor GPS signal: 

Your device may have lost GPS signal. That may happen when your GPS tracker is 

covered by a thick surface or if your device is inside a building, underground or near tall buildings.

6. How long should I charge the device to fully charge the battery?

Eight hours of charge is enough. The device is fully charged after 8 hours or when the RED Power 

LED is solid

7. My device reports a location that is slightly off from the actual location. 

Accuracy depends on many factors beyond our control. For example: weather, clouds, tall buildings 

or trees, bodies of water and device location. 

Will work for some minutes for testing 

purposes and then it will go to 

sleep mode

to save battery.

Frequently asked questions

Dear Customer. This section contains very important information. Please do not skip it.

Led behavior

Reviews: