Installation Instructions
400-279
700-510 Airaid Oiled Media Filter
401-279
701-510 SynthaMax Dry Media Filter - Red
2017-19 FORD F-250 / F-350 / F-450
V8-6.7L Turbo Diesel
For Part Numbers:
Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance please call 1-800-498-6951 to speak with
a representative in our Customer Service Center before returning the product.
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories. Write
down all memory settings before disconnecting the
negative battery cable. Some radios will require
an anti-theft code to be entered after the battery is
reconnected. The anti-theft code is typically supplied
with your owner’s manual. In the event your vehicles
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles anti-
theft code.
TO START:
A
A
C
D
E
F
G
H
I
K
J
H
I
L
M
N
O
P
B
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamp that secures the factory
intake tube to the turbo inlet, release the four clips that
secure the upper air filter housing and then remove the
assembly from the vehicle.
4. Remove the two bolts that secure the lower air filter
housing to the mounting bracket, then pull the lower
air filter housing straight up to dislodge it from the
mounting grommets and remove it from the vehicle.
NOTE: AIRAID recommends that customers do not
discard factory air intake.
Component Identification
Description
Qty. Part #
Description
Qty. Part #
Description
Qty. Part #
A
HOSE CLAMP #72
2
08671
B
HOSE; HUMP 4.5"ID X 3"L
1
08695
C
INTAKE TUBE
1
KIT279
D
SPACER; .437"OD X .200"ID
2
06503
E
SCREW; M4- .7 X 12, BUTTON SS
2
07726
F
MAF EXTENSION HARNESS
1
21780
G
WASHER; 1"D X 1/4 HOLE
2
08160
H
WASHER, M6 SPLIT LOCK ZINC
3
1-3025
I
BOLT; 6MM-1.00 X 16MM, SS
3
07812
J
WASHER; 6MM FLAT, SS
1
08269
K
MOUNT, PLASTIC AIRBOX
1
8-186-1
L
HOSE CLAMP; #104
1
08697
M
AIRAID FILTER
1
700/701-510
N
AIR BOX
1
KIT279CAB
O
PLUG; 1-3/16"OD, 11/16"ID
1
21684-1
P
EDGE TRIM (26-3/8")
1
KITSTRIP22
5. Remove the two bolts that secure the air filter housing
mounting bracket to the inner fender and remove the
bracket from the vehicle.
6. Install the provided air box mounting stud onto the
AIRAID
®
housing using the provided hardware.
