background image

INTERNAL-TELEPHONE SYSTEM

TC-M Series

TC-10M:

10-call master

TC-20M:

20-call master

Models:

INSTALLATION & OPERATION MANUAL

PRECAUTIONS ON INSTALLATION & WIRING

GENERAL PRECAUTIONS 

DISMANTLE
PROHIBITIONS

GENERAL PROHIBITIONS

Examples of Symbols;

This Manual and the Markings on the product contain various 
symbols in order that the product can be used safely and properly, 
and that the installer and user are protected from injury and 
property damage. The following precautions must be thoroughly
 read and understood before proceeding.

TC-20M

The        mark indicates caution 
statement (incl. danger and warning), 
which is specifically shown inside. 

 

All the products of other manufacturers, power supply, buzzer, etc. used for TC-M, are not within our warranty, 

    and must be used under manufacturer or distributor's specifications and warranty.

The       mark indicates contents 
which demands a specific 
action shown inside or attached.

The       mark indicates contents 
which prohibit a specific action 
shown inside or attached.

MOISTURE
PROHIBITIONS

1. TC-M equipment is designed for indoor use only.
    Do not install outdoors.
2. TC-M system is not operational during a power failure.
3. In areas where broadcasting station antennas are close by, 
    intercom system may be affected by radio frequency interference.
4. Keep all DC wiring at least 30cm, 1' away from AC 100~240V 
    wiring, fluorescent lighting, or dimmer switches.
    Otherwise, cross AC wiring at a 90

°

 angle.

 Weather conditions, such as lightning storms, may cause damage 

    to TC-M equipment.  It is suggested to take protective measures 
    as follows;
    • When an AC transformer is used

    • When a DC power supply is used:
      On the power supply with grounding terminal, be sure to take the 
      terminal to earth ground.
      In this case, it is not necessary to connect a surge-arrester.

    When using a power supply that has no grounding terminal, 
    install a surge-arrester in the same manner as stated above. 
    Surge-arrester SA-1 is available from Aiphone.

  1. Do not connect any power source other than specified on 
      TC-M master.  Fire or damage to the unit could result.
  2. Do not open TC-M master.  High voltage is present inside, 
      and it can cause electric shock. 
  3. Do not change or alter TC-M master.  It can cause fire 
      or electric shock.
  4. Make sure wires are connected properly before plugging in 
      power supply.
  5. Keep TC-M master away from water or any other liquid. 
      Fire or electric shock could result.
  6. Keep AC plug away from moisture or dust.
  7. Keep AC cord away from being marred or crushed. 
  8. Do not plug or unplug with wet hands.
  9. Do not put any metal into TC-M through openings.
      It can cause fire, electric shock or unit damage.

    - 

Places subject to moisture or humidity extremes.

    - 

Places subject to environmental conditions

,

    such as oil, dust, chemicals, salt, etc.
    - 

Places subject to constant vibration or impact.

    - 

Places where noise generating devices such as 

   TV or radio are close by.

WARNING

Negligence could result in death or serious injury.

CAUTION

Negligence could result in injury or damage to property.

WARNING

CAUTION

1. Do not make call tone testing with hook switch manually held down.
    The call tone sounds very loud near your ears, and can cause 
    your hearing damage.
2. Do not install or make any wire terminations while power supply 
    is plugged in. It can cause electrical shock or damage to the unit.
3. Install TC-M master in a convenient location, but not 
    where it could be bumped or jarred.
4. In case of electrical storms, unplug power supply from AC outlet.
    It can cause fire, electric shock, or power surge damage.
5. Do not install TC-M components in any of the following locations, 
    as it may cause the system to malfunction;

    - 

High or extreme cold temperature area:

    under direct sunlight, near equipment that varies in temperature, 
    in front of air conditioner, inside a refrigerated area, etc.

GENERAL PRECAUTIONS

GENERAL INSTRUCTIONS

TC-10M

AC trans.

TC-10M   TC-20M

AC 15 – 16V
or DC 18V

Surge-
arrester

Install a surge-arrester
(discharging voltage: 

100~180V

)

at a point close to the output,
taken to earth ground.

Grounded

– 1 –

83945900 0102 A

A

Содержание Tc-10m













Отзывы: