N.B. This equipment must be installed by a competent person.
Instructions for:
VB543
Solo Compact Shower Seat
115 kg (18 st.) weight limit
VB633
Solo Cuxton Shower Seat
115 kg (18 st.) weight limit
VB548
Hunton Standard Shower Seat
190 kg (30 st.) weight limit
VB544
Solo Compact Shower Seat with Leg
159 kg (25 st.) weight limit
VB535
Solo Deluxe Shower Chair (Padded)
190 kg (30 st.) weight limit
VB539
Solo Deluxe Shower Chair
190 kg (30 st.) weight limit
VB542
Solo Compact Shower Seat Padded
115 kg (18 st.) weight limit
VB634
Solo Standard Shower Chair Padded
190 kg (30 st.) weight limit
VB546
Hunton Deluxe Shower Seat
190 kg (30 st.) weight limit
VB532
Solo Standard Shower Seat
190 kg (30 st.) weight limit
VB629
Solo Cuxton Shower Seat
159 kg (25 st.) weight limit
UU
Do not
UU
exceed the weight limit stated – doing so could put the user at
UU
risk
UU
.
Fixing and Maintenance Instructions
Shower Chairs & Seats
09/11/10
1011
1. All Shower Seats
Please examine your shower seat for any visible damage before using. If you see any damage or suspect a fault,
please contact your supplier.
In this case, please do not use your product as it may compromise your safety.
U
2. Cleaning
All of the product components are manufactured from quality materials. However, it is very important that you only
clean your shower chairs and stools using a non-abrasive cleaner or mild detergent with a soft cloth avoid using lime
scale remover. Abrasive cleaners e.g. AJAX and or abrasive cleaning pads will seriously damage your product beyond
repair.
Certain products have clip on/clip off backs and/or seats, you can easily remove these if required, clean with a mild
detergent and soft cloth in a warm water solution. Do not exceed 50
o
C when cleaning the seat cover and/or back as
this will permanently damage the plastic.
N.B. Regular daily cleaning will reduce the build up of limescale on your product.
Under No Circumstances use any abrasive cleaners or materials on any of the components. Also check that the
cleaner you intend to use is suitable for ABS, Vinyl, Polymer Plastics and Thermo plastic rubbers and Polyurethane
Rubber.
3. Adjustments to Extension Legs (if applicable)
Please adjust the legs prior to installation. Remove the ‘E’ clip from the extension leg and extend all four legs evenly
to the desired height ensuring you do not exceed the last punched hole of the extension leg. (see fig. 1)
Once you have achieved the desired height; reinstall the ‘E’ clip, ensuring that it has passed through the extension
leg and is fitting neatly and snug around the outside leg. (see fig. 2).
Never install the extension legs unevenly or slanting, this will compromise the safety of the user.
