ES360 QUICK START GUIDE
360
To register your scanner and download the installer, go to
h
Ʃ
p://www.3dker.com/en and create an account. Select the
A
fi
nia
3D
scanner model and enter your Serial Number to begin the down-
load.
A USB s
Ɵ
ck with the so
Ō
ware installer is also included with your
scanner.
Support Webpage:
a
fi
nia.com/support
For Email Support:
support@a
fi
nia.com
For Phone Support:
USA (M-F 8-5 CT): 952.279.2643
UK: +44 (0)845 230 7800
Japan: 03-3561-2266
www.a
fi
nia.com
2015.07.29
Put the box on a stable surface, cut the tape and open the box.
Remove the inner box and open. Pull foam carefully from inner box
and pull foams apart. Carefully take out scanner and turntable; set
spare parts aside for now.
Set the turntable and scanner in the outlines on the posi
Ɵ
oning sheet.
Plug the power cable, VGA cable, and USB cable into the speci
fi
ed
connec
Ɵ
ons on the scanner and turntable. Plug the other ends of
the cables into the computer and outlet. Turn on the scanner by
pressing the power bu
Ʃ
on twice.
NOTE:
The scanner USB cable can only be connected to the PC using
a USB 2.0 port.
Adjust the angle of the scanner so the lower edge of the projec
Ɵ
on
approaches the second loop of the turntable;
Ɵ
ghten the scanner
mount bolt.
Assemble the frame for the Calibra
Ɵ
on Board as shown in the image
above, then slide the calibra
Ɵ
on board into the frame.
NOTE: During calibra
Ɵ
on, the frame should not be moved - rotate the
calibra
Ɵ
on board instead.
Grooves
should be open
at the top
