Installation instructions
LED
UNDERWATER LIGHTING INSTALLATION INSTRUCTIONS
Please read the instruction carefully before installation.
Low voltage single color fitting:use external power supply,the input voltage of power supply must be
consistent with the requested input voltage of the fitting,as the fitting is constant voltage input type.
The power consumption of power supply must be decided by installer according to the requirements from
the site.
Example of wiring:
100-240V
Power(DC24V)
2-1.Fasten the nut with the screw by using
a tool.
1-1.Put the wave tube through the nut and the
rubber plug.
#The wave tube should reach the bottom of
the rubber plug#
6-1.Put the mounting sleeve into the holes .
6-2. Fasten it with the wall of the pool by a
screwdriver .
5-1.Fix the two type“L”bracket on the
mounting sleeve.
5-2.Dig a hole for the installation for each of
the mounting sleeve.
#The distance between these holes and
the ground should less than 1m.#
7-2.Turn on the power to make sure it is working .
7-3. Fix the light with the mounting sleeve by a
screwdriver.
7-1.Connect the lighting fixture with the power
cable by the connector .
#fasten the connector tightly to make sure
it can reach IP68.#
8-1.Pour the water into the pool after the
installation.
3-1.Put the cable through the wave
tube and the hole of the mounting
sleeve from outside .
3-2.Then insert the cable into the nut/rubber
plug and the screw of the PG13.5.
3-3.Fix the nut with screw of the PG13.5 tightly.
4-1.Screw the PG13.5 with the connector on
the wave tube tightly with two wrenches.
4-2.Fix the backcover to the mounting sleeve
by four screw.
165mm
<1m
>165mm
<1m
